Infiniti EX30 Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Infiniti EX30
The Infiniti EX is an entry-level luxury crossover. It is based on the same FM platform as the Infiniti G, M, and FX models. The EX is the marque's entry-level crossover and slots below the FX. The Infinity EX30d was launched in the 2010 Geneva Motor Show. The brand entered the European market with new 3.0-litre V6 diesel. The engine, the first in the brand s 20-year history. It will initially available in the EX and FX crossovers, and later in the Infiniti M sedan.Infiniti EX30 FAQ's
How do I change a headlight bulb in my Infiniti EX30?
To change a headlight bulb in your Infiniti EX30, open the hood and locate the backside of the headlight assembly. Disconnect the electrical connector from the bulb and remove the bulb retaining clip or cover. Carefully remove the old bulb and replace it with a new bulb, ensuring it is properly seated. Reconnect the electrical connector and test the headlight before closing the hood.
How do I change the oil in my Infiniti EX30?
To change the oil in your Infiniti EX30, you will need to locate the oil drain plug underneath the vehicle and remove it to drain the old oil. Once the old oil has drained completely, you can then replace the drain plug and remove the oil filter. After installing a new oil filter, you can then refill the engine with the recommended amount and type of oil specified in the Infiniti EX30 automotive repair manual.
How do I check the brake fluid level in my Infiniti EX30?
To check the brake fluid level in your Infiniti EX30, locate the brake fluid reservoir under the hood. The reservoir should have a maximum and minimum level indicator. Ensure the vehicle is on a level surface, remove the cap from the reservoir, and visually inspect the fluid level. If it is below the minimum level, add the recommended brake fluid as specified in the Infiniti EX30 automotive repair manual.
How do I check the tire pressure in my Infiniti EX30?
To check the tire pressure in your Infiniti EX30, first, ensure the tires are cool. Locate the tire valve stem, remove the valve cap, and press a tire pressure gauge onto the valve stem. The gauge will display the current tire pressure. Compare the reading to the recommended tire pressure listed in the Infiniti EX30 automotive repair manual. If the tire pressure is low, add air until it reaches the recommended level.
How do I check the transmission fluid level in my Infiniti EX30?
To check the transmission fluid level in your Infiniti EX30, park the vehicle on a level surface and start the engine. Allow the engine to reach operating temperature. Locate the transmission dipstick, usually near the back of the engine bay. With the engine running, pull out the dipstick, wipe it clean, reinsert it, and pull it out again. Check the fluid level against the markings on the dipstick. If the level is low, add the recommended transmission fluid as specified in the Infiniti EX30 automotive repair manual.
How do I diagnose a check engine light in my Infiniti EX30?
When the check engine light illuminates in your Infiniti EX30, it is an indication of a potential issue with the engine or emissions system. To diagnose the problem, you can use an OBD-II scanner to retrieve the diagnostic trouble code (DTC) associated with the check engine light. Once you have the DTC, refer to the Infiniti EX30 automotive repair manual or consult a professional mechanic to determine the specific cause and necessary repairs.
How do I perform a battery test in my Infiniti EX30?
To perform a battery test in your Infiniti EX30, you will need a digital multimeter. Set the multimeter to the DC voltage setting and connect the positive (red) lead to the positive terminal of the battery and the negative (black) lead to the negative terminal. Read the voltage on the multimeter display. If the voltage is below the recommended range specified in the Infiniti EX30 automotive repair manual, the battery may need to be charged or replaced.
How do I program a new key fob for my Infiniti EX30?
To program a new key fob for your Infiniti EX30, insert the key into the ignition and turn it to the "ON" position without starting the engine. Within 10 seconds, press and release the "LOCK" button on the new key fob, then turn the ignition off. Repeat this process up to four times for additional key fobs. After the final key fob has been programmed, turn the ignition to the "OFF" position to complete the programming process.
How do I replace a blown fuse in my Infiniti EX30?
To replace a blown fuse in your Infiniti EX30, locate the fuse box, which is typically located in the engine compartment or under the dashboard. Refer to the fuse box diagram in the Infiniti EX30 automotive repair manual to identify the specific fuse that needs to be replaced. Use a fuse puller or needle-nose pliers to remove the blown fuse and replace it with a new fuse of the same amperage rating.
How do I replace a brake pad in my Infiniti EX30?
To replace a brake pad in your Infiniti EX30, first, locate the brake caliper, which is usually mounted on the front or rear rotor. Remove the caliper bolts or pins to access the brake pads. Take out the old brake pads and install the new ones, ensuring they are properly aligned and seated. Reinstall the caliper bolts or pins, and repeat the process for the remaining brake pads.
How do I replace a serpentine belt in my Infiniti EX30?
To replace the serpentine belt in your Infiniti EX30, locate the belt tensioner, which is typically located near the front of the engine. Use a wrench or socket to rotate the tensioner and release the tension on the belt. Slide the old belt off the pulleys, making note of the routing. Install the new belt, following the proper routing as outlined in the Infiniti EX30 automotive repair manual. Finally, release the tensioner to apply tension to the new belt.
How do I replace the cabin air filter in my Infiniti EX30?
To replace the cabin air filter in your Infiniti EX30, locate the cabin air filter housing, which is usually located behind the glove compartment or under the dashboard. Remove the cover of the housing and take out the old cabin air filter. Install a new cabin air filter, making sure it is properly aligned and fits snugly. Replace the housing cover and ensure it is securely fastened.
How do I reset the maintenance light on my Infiniti EX30?
To reset the maintenance light on your Infiniti EX30, turn the ignition to the "ON" position without starting the engine. Within 10 seconds, fully depress the accelerator pedal five times. Wait for about 10 seconds until the maintenance light starts flashing, indicating that it has been reset. Turn off the ignition and start the engine to ensure the maintenance light is no longer illuminated.
How often should I replace the air filter in my Infiniti EX30?
It is recommended to replace the air filter in your Infiniti EX30 every 12,000 to 15,000 miles or as specified in the maintenance schedule provided in the Infiniti EX30 automotive repair manual. Regular replacement of the air filter is important to ensure proper airflow to the engine, which can improve fuel efficiency and overall performance.
What type of coolant should I use for my Infiniti EX30?
For optimal performance and protection, it is recommended to use a genuine Infiniti coolant or a high-quality ethylene glycol-based coolant that meets or exceeds the specifications outlined in the Infiniti EX30 automotive repair manual. Using the correct type and mixture of coolant is crucial to prevent overheating and maintain the longevity of the engine.
Get notified for new manuals?
We'll send you a quick email when a new Infiniti EX30 manual is added.
There are currently no manuals available for Infiniti EX30 at this time.