Pontiac Impulse Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Pontiac Impulse
The Chevrolet Celebrity is a mid-size car produced by the Chevrolet division of General Motors. The Celebrity was introduced in 1981 for the 1982 model year. The Celebrity was the best-selling car in the United States in 1986. Although sold for only one generation, it received its first facelift in 1984, and the other in 1986, which included a facelifted front end and restyled taillights. The Celebrity's last facelift was in 1987, when composite headlamps replaced the quad rectangular sealed beam units. The coupe was discontinued after 1988. Celebrity sedan production ended on July 7, 1989, while the wagon was discontinued in early 1990, with the new Lumina line replacing it.Pontiac Impulse FAQ's
How do I change the brake pads in a Pontiac Impulse?
To change the brake pads in a Pontiac Impulse, start by safely lifting the vehicle and removing the wheel. Locate the brake caliper and remove the bolts that hold it in place. Carefully remove the caliper, making sure not to damage the brake line, and compress the caliper piston using a C-clamp or brake caliper tool. Remove the old brake pads and install the new ones, ensuring they are properly aligned. Reinstall the caliper, tighten the bolts, and repeat the process for the other wheels.
How do I change the oil in a Pontiac Impulse?
To change the oil in a Pontiac Impulse, start by locating the oil drain plug underneath the engine. Use a wrench to remove the plug and allow the old oil to drain into a pan. Once drained, replace the plug and refill the engine with the recommended amount and type of oil specified in the manual.
How do I check the tire pressure in a Pontiac Impulse?
To check the tire pressure in a Pontiac Impulse, start by ensuring that the tires are cold. Locate the tire pressure placard, usually located inside the driver's door jamb or in the owner's manual, and note the recommended tire pressure. Use a tire pressure gauge to measure the pressure of each tire, ensuring it matches the recommended pressure. If needed, add or release air until the desired pressure is achieved.
How do I check the transmission fluid level in a Pontiac Impulse?
To check the transmission fluid level in a Pontiac Impulse, start the engine and allow it to idle for a few minutes to warm up. Locate the transmission dipstick, usually labeled and located near the back of the engine bay. Remove the dipstick, wipe it clean, and reinsert it fully. Remove the dipstick again and check the fluid level, which should be within the designated range. If needed, add the recommended transmission fluid through the dipstick tube, being careful not to overfill.
How do I perform a coolant flush on a Pontiac Impulse?
Performing a coolant flush on a Pontiac Impulse involves draining the old coolant from the system and replacing it with fresh coolant. Start by allowing the engine to cool down, then locate the radiator drain plug or petcock and open it to drain the coolant into a suitable container. Once drained, close the drain plug and refill the system with a mixture of coolant and distilled water according to the manufacturer's specifications. Bleed any air from the system, check for leaks, and monitor the coolant level regularly to ensure proper engine cooling.
How do I replace a burnt-out headlight in a Pontiac Impulse?
To replace a burnt-out headlight in a Pontiac Impulse, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector and remove the retaining clips or screws that hold the headlight bulb in place. Carefully remove the old bulb, avoiding touching the glass with bare hands, and replace it with a new bulb. Secure the bulb with the retaining clips or screws, reconnect the electrical connector, and test the new headlight.
How do I replace the fuel filter in a Pontiac Impulse?
To replace the fuel filter in a Pontiac Impulse, start by locating the filter, which is typically mounted along the fuel line, near the fuel tank or engine. Ensure the engine is cool and relieve the fuel system pressure by removing the fuel pump fuse or relay and allowing the engine to idle until it stalls. Use a wrench or specialized tool to disconnect the fuel lines from the filter, taking note of their orientation. Install the new filter, reconnect the fuel lines, and reinstall the fuel pump fuse or relay.
How do I replace the serpentine belt in a Pontiac Impulse?
To replace the serpentine belt in a Pontiac Impulse, locate the belt tensioner, which is usually spring-loaded and can be released using a wrench or socket. Rotate the tensioner to relieve tension on the belt and slide it off the pulleys. Carefully route the new serpentine belt around the appropriate pulleys, following the diagram located in the engine bay. Apply tension to the belt by rotating the tensioner again and ensure it is properly seated on all pulleys.
How do I replace the spark plugs in a Pontiac Impulse?
To replace the spark plugs in a Pontiac Impulse, start by locating the spark plug wires or ignition coils, depending on the specific engine configuration. Disconnect the wires or coils and use a spark plug socket and ratchet to remove the old spark plugs. Inspect the new spark plugs for any damage and apply a small amount of anti-seize compound to the threads. Install the new spark plugs, tighten them to the specified torque, and reconnect the wires or coils. Repeat the process for each spark plug.
How do I replace the windshield wipers in a Pontiac Impulse?
To replace the windshield wipers in a Pontiac Impulse, lift the wiper arm away from the windshield and locate the release tab or button near the wiper blade. Depress the tab or button and slide the old wiper blade off the wiper arm. Align the new wiper blade with the arm and push it until it clicks into place. Gently lower the wiper arm back onto the windshield, ensuring proper contact and operation.
How do I reset the check engine light in a Pontiac Impulse?
Resetting the check engine light in a Pontiac Impulse usually requires an OBD-II scanner. Connect the scanner to the vehicle's OBD-II port, which is usually located under the dashboard on the driver's side. Follow the scanner's instructions to retrieve and clear the trouble codes. If the issue causing the check engine light persists, it is recommended to consult a professional mechanic for further diagnosis and repair.
How do I troubleshoot a Pontiac Impulse that won't start?
If a Pontiac Impulse won't start, there could be several potential causes. Check the battery to ensure it has sufficient charge and the connections are clean and tight. Inspect the fuel system for any issues, such as a clogged fuel filter or fuel pump failure. Verify that the ignition system is functioning properly, including spark plugs, ignition coils, and the starter. If troubleshooting these components doesn't resolve the issue, it is recommended to consult a professional mechanic for further diagnosis and repair.
How often should I replace the air filter in a Pontiac Impulse?
The air filter in a Pontiac Impulse should be replaced according to the manufacturer's recommended maintenance schedule, typically every 12,000 to 15,000 miles or as indicated in the manual. However, this frequency can vary depending on driving conditions and air quality in your area. Regularly inspect the air filter and replace it if it appears dirty or clogged to maintain proper engine performance and fuel efficiency.
What type of coolant should I use in a Pontiac Impulse?
It is recommended to use a coolant that is compatible with the Pontiac Impulse's engine. Check the owner's manual or service guide for the specific coolant type and specifications. Make sure to use a coolant that meets the manufacturer's requirements to ensure optimal performance and prevent any potential damage to the cooling system.
Get notified for new manuals?
We'll send you a quick email when a new Pontiac Impulse manual is added.
There are currently no manuals available for Pontiac Impulse at this time.