Mercedes E 300 Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Mercedes E 300
The Mercedes-Benz E-Class is a range of executive cars manufactured by Mercedes-Benz in various engine and body configurations produced since 1992. The Mercedes-Benz E 300 was produced in several versions since 1993. It was manufactured as 4-door sedan, 2-door cabriolet, 5-door combi wagon, 2-door coupe and 5 door estate wagon. This model is manufactured with both petrol and diesel engines, and both manual and automatic transmission styles are available. Its top speed is listed as 250 km/h and can accelerate from 0 to 100 km/h in 6.9 seconds. It is still in production.
Mercedes E 300 FAQ's
How do I check the brake fluid level in a Mercedes E 300?
To check the brake fluid level in a Mercedes E 300, locate the brake fluid reservoir, which is typically located near the firewall in the engine compartment. The reservoir has a translucent plastic cap marked with "MIN" and "MAX" indicators. Ensure the vehicle is parked on a level surface, remove the cap, and visually inspect the fluid level. If the level is below the "MIN" mark, add the recommended brake fluid type to bring it to the proper level.
How do I check the coolant level in a Mercedes E 300?
To check the coolant level in a Mercedes E 300, park the vehicle on a level surface and allow the engine to cool down. Open the hood and locate the coolant expansion tank, which is typically translucent. The coolant level should be between the "MIN" and "MAX" marks on the side of the tank. If the level is low, add a mixture of coolant and distilled water until it reaches the proper level.
How do I check the transmission fluid level in a Mercedes E 300?
To check the transmission fluid level in a Mercedes E 300, start the engine and allow it to reach normal operating temperature. Park the vehicle on a level surface and engage the parking brake. Locate the transmission dipstick, usually near the back of the engine compartment. Pull out the dipstick, wipe it clean, then reinsert it fully. Remove the dipstick again and check the fluid level against the markings on the dipstick. If the level is low, add the recommended transmission fluid through the dipstick tube.
How do I jump-start a Mercedes E 300?
To jump-start a Mercedes E 300, park a vehicle with a functioning battery close to the E 300. Connect the positive (red) clamp of the jumper cables to the positive terminal of the dead battery, then connect the other positive clamp to the positive terminal of the working battery. Next, connect the negative (black) clamp to the negative terminal of the working battery and attach the other negative clamp to a metal surface on the engine block of the E 300, away from the battery. Start the vehicle with the working battery, then attempt to start the E 300.
How do I replace a fuse in a Mercedes E 300?
To replace a fuse in a Mercedes E 300, open the fuse box, which is usually located in the engine compartment or under the dashboard. Identify the fuse that needs to be replaced by referring to the fuse diagram in the owner's manual or on the fuse box cover. Use a fuse puller or a pair of needle-nose pliers to remove the faulty fuse. Insert a new fuse of the same amperage rating into the appropriate slot, ensuring it is securely seated.
How do I replace a headlight bulb on a Mercedes E 300?
To replace a headlight bulb on a Mercedes E 300, open the hood and locate the back of the headlight assembly. Twist and remove the bulb holder counterclockwise, then disconnect the electrical connector. Replace the old bulb with a new one, making sure not to touch the glass part. Reconnect the electrical connector, insert the bulb holder back into the headlight assembly, and twist it clockwise to secure it.
How do I replace the air filter in a Mercedes E 300?
To replace the air filter in a Mercedes E 300, open the hood and locate the air filter housing, which is usually on the driver's side. Unclip the latches or screws securing the housing, then remove the cover. Take out the old air filter and replace it with a new one, ensuring it is properly seated. Reattach the housing cover and secure it with the latches or screws.
How do I replace the cabin air filter in a Mercedes E 300?
To replace the cabin air filter in a Mercedes E 300, locate the cabin air filter housing, which is usually behind the glove compartment or under the dashboard. Open the housing by removing the retaining clips or screws. Take out the old filter and discard it. Install the new filter, ensuring it is oriented correctly and properly seated. Reattach the housing cover and secure it with the retaining clips or screws.
How do I replace the wiper blades on a Mercedes E 300?
To replace the wiper blades on a Mercedes E 300, lift the wiper arm away from the windshield and locate the small tab or button near the base of the wiper blade. Press the tab or button and slide the old wiper blade down and off the wiper arm. Attach the new wiper blade by sliding it onto the wiper arm until it clicks into place. Gently lower the wiper arm back onto the windshield.
How do I reset the maintenance reminder on a Mercedes E 300?
To reset the maintenance reminder on a Mercedes E 300, follow these steps: 1) Turn the ignition to position 1 (without starting the engine). 2) Press the arrow buttons on the multifunction steering wheel until the service symbol appears. 3) Press and hold the "OK" button on the steering wheel until the "Reset?" message appears. 4) Release the "OK" button, then press and hold it again until the "Reset Complete" message is displayed.
How do I reset the tire pressure monitoring system on a Mercedes E 300?
To reset the tire pressure monitoring system on a Mercedes E 300, ensure all tires are properly inflated to the recommended pressure. Start the engine and drive the vehicle at a speed above 20 mph for at least 10 minutes. The system will automatically reset and recalibrate itself, and any warning lights related to tire pressure should turn off.
How often should I change the engine oil in a Mercedes E 300?
The engine oil in a Mercedes E 300 should be changed every 10,000 miles or once a year, whichever comes first. Regular oil changes are essential to maintain optimal engine performance, prevent excessive wear, and extend the overall lifespan of the engine.
What is the recommended tire pressure for a Mercedes E 300?
The recommended tire pressure for a Mercedes E 300 is typically around 32 PSI (pounds per square inch) for the front tires and 35 PSI for the rear tires. However, it is always best to refer to the specific tire pressure guidelines provided by Mercedes in the owner's manual or on the door jamb sticker.
What type of engine oil should I use for a Mercedes E 300?
For a Mercedes E 300, it is recommended to use synthetic engine oil with the appropriate viscosity grade, which is typically 0W-40 or 5W-40. Synthetic oil provides superior lubrication and thermal stability, ensuring optimal engine protection and performance.
Get notified for new manuals?
We'll send you a quick email when a new Mercedes E 300 manual is added.