Mercedes S 250 Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Mercedes S 250
The Mercedes-Benz S-Class is a series of full-size luxury sedans produced by the German automaker Mercedes-Benz, a division of German company Daimler AG. The classification was officially introduced in 1972. Mercedes S 250 is a four-door sedan manufactured between 2011 and 2013. It is available as rear-wheel drive. It is produced with 2,143 cc diesel engines. This model s engine can produce power of 150 kW. It can accelerate from 0 to 100 km/h in 8.2 seconds, and its top speed is listed as 240 km/h. Car is available with automatic transmission style. The S-Class has ranked as the world's best-selling luxury sedan. The S-Class was Wheels Magazine Car of the Year for 1981 and 1999.
Mercedes S 250 FAQ's
How do I change a flat tire on a Mercedes S 250?
To change a flat tire on a Mercedes S 250, start by finding a safe location away from traffic and turning on the hazard lights. Locate the spare tire, jack, and lug wrench in the trunk. Use the lug wrench to loosen the lug nuts on the flat tire, but do not fully remove them. Place the jack in the designated lifting point near the flat tire and raise the vehicle until the flat tire is off the ground. Remove the lug nuts completely and take off the flat tire. Mount the spare tire onto the wheel hub, hand-tighten the lug nuts, lower the vehicle, and then use the lug wrench to securely tighten the lug nuts in a star pattern. Finally, check the tire pressure of the spare tire and adjust if necessary.
How do I change the oil in a Mercedes S 250?
To change the oil in a Mercedes S 250, first, locate the oil drain plug underneath the vehicle. Use a wrench to loosen and remove the drain plug, allowing the old oil to drain into a drain pan. Once the oil has fully drained, replace the drain plug and proceed to remove the old oil filter, replacing it with a new one. Finally, refill the engine with the recommended amount and type of fresh oil.
How do I check the brake fluid level in a Mercedes S 250?
To check the brake fluid level in a Mercedes S 250, locate the brake fluid reservoir, which is typically located near the firewall on the driver's side of the engine bay. Ensure the vehicle is parked on a level surface and the engine is off. Clean the area around the reservoir cap to prevent any debris from entering the system. Remove the reservoir cap and visually inspect the fluid level. The brake fluid level should be between the minimum and maximum markings on the reservoir. If the level is low, add the recommended brake fluid until it reaches the proper level. Be cautious not to spill brake fluid on any painted surfaces, as it can cause damage.
How do I check the transmission fluid in a Mercedes S 250?
To check the transmission fluid in a Mercedes S 250, start the engine and let it idle for a few minutes to warm up. Locate the transmission dipstick, which is usually near the back of the engine bay. Remove the dipstick, wipe it clean, and reinsert it fully. Withdraw the dipstick again and check the fluid level indicated on the dipstick. The level should be within the designated range. If the fluid level is low, add the recommended transmission fluid through the dipstick tube, using a funnel if necessary. It's important to use the correct type of transmission fluid as specified in the owner's manual.
How do I jump-start a Mercedes S 250?
If your Mercedes S 250's battery is dead, you can jump-start it using a set of jumper cables and a functioning vehicle with a charged battery. First, position the two vehicles close enough so that the jumper cables can reach both batteries. Make sure both vehicles are turned off. Connect the red jumper cable clamp to the positive terminal of the dead battery and then to the positive terminal of the charged battery. Connect one end of the black jumper cable to the negative terminal of the charged battery and the other end to an unpainted metal surface on the dead vehicle. Start the functioning vehicle and let it run for a few minutes. Then, try starting the Mercedes S 250. Once it starts, remove the jumper cables in the reverse order of how they were connected.
How do I replace a
How do I replace a cabin air filter in a Mercedes S 250?
To replace a cabin air filter in a Mercedes S 250, start by locating the cabin air filter housing, which is usually behind the glove compartment. Open the glove compartment and remove any items or contents. Depress the tabs or release mechanisms on both sides of the glove compartment to allow it to swing down or fully remove it, depending on the specific model. Locate the cabin air filter housing cover and remove it by releasing the latches or screws. Take out the old cabin air filter and replace it with a new one, ensuring it is properly aligned. Reinstall the housing cover, reattach the glove compartment, and test the air conditioning or ventilation system to ensure proper airflow.
How do I replace a fuel filter in a Mercedes S 250?
To replace a fuel filter in a Mercedes S 250, start by locating the fuel filter, which is generally positioned along the fuel line under the vehicle or inside the fuel tank. Ensure the vehicle is turned off and the fuel system is depressurized. If the fuel filter is external, disconnect the fuel lines from both ends of the filter using the appropriate tools. Install the new fuel filter, making sure it is properly aligned and securely connected to the fuel lines. If the fuel filter is located inside the fuel tank, it is recommended to consult a professional technician, as special tools and expertise may be required.
How do I replace a headlight bulb in a Mercedes S 250?
To replace a headlight bulb in a Mercedes S 250, first, open the hood and locate the back of the headlight assembly. Depending on the specific model, you may need to remove a cover or access panel to reach the bulb. Once you have access, disconnect the electrical connector from the bulb and remove the retaining clip or ring holding it in place. Carefully remove the old bulb and replace it with a new one of the same type. Reattach the retaining clip or ring, reconnect the electrical connector, and test the new bulb before closing the access panel or cover.
How do I replace the windshield wiper blades on a Mercedes S 250?
To replace the windshield wiper blades on a Mercedes S 250, first, lift the wiper arm away from the windshield until it locks into a raised position. Locate the release mechanism on the wiper blade, which may vary depending on the specific model. Depress or squeeze the release mechanism and slide the old wiper blade off the wiper arm. Align the new wiper blade with the wiper arm and push it into place until it clicks or locks securely. Gently lower the wiper arm back onto the windshield, ensuring that the new wiper blade is properly positioned and makes full contact with the glass.
How do I reset the maintenance light in a Mercedes S 250?
To reset the maintenance light in a Mercedes S 250, start by turning the ignition on without starting the engine. Use the controls on the steering wheel or the dashboard to navigate to the vehicle's settings menu. Locate the "Maintenance" or "Service" submenu and select it. From there, you should find an option to reset the maintenance light. Follow the on-screen prompts or consult the owner's manual for detailed instructions on resetting the specific model of the Mercedes S 250.
How often should I replace the air filter in a Mercedes S 250?
The air filter in a Mercedes S 250 should be replaced regularly to maintain proper engine performance and fuel efficiency. It is generally recommended to replace the air filter every 15,000 to 30,000 miles or as indicated by the vehicle's maintenance schedule. However, the frequency may vary depending on driving conditions and air quality in your area. Inspecting the air filter regularly and replacing it when it appears dirty or clogged is essential for optimal engine performance.
What is the recommended tire pressure for a Mercedes S 250?
The recommended tire pressure for a Mercedes S 250 can vary depending on the specific model and tire size. However, the ideal tire pressure can usually be found on a sticker located on the driver's side door jamb or in the owner's manual. It is crucial to maintain the recommended tire pressure to ensure proper handling, tire life, and fuel efficiency. Regularly check the tire pressure and adjust it as needed to keep it within the manufacturer's recommended range.
What type of coolant should I use in a Mercedes S 250?
For optimal performance and to prevent any potential damage, it is recommended to use Mercedes-approved coolant in a Mercedes S 250. This coolant should meet the specifications outlined in the vehicle's owner's manual and be specifically formulated for Mercedes-Benz vehicles. It's important to avoid using generic or incompatible coolant, as it may not provide the necessary protection and can lead to overheating or corrosion issues.
Get notified for new manuals?
We'll send you a quick email when a new Mercedes S 250 manual is added.