Rover Streetwise Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Rover Streetwise
The Rover Streetwise was a small British car made by MG Rover. It was based on the Rover 25, but had an increased ride height and chunkier bumpers. The tough-looking Streetwise was designed as a two-wheel drive urban car with 4x4 looks. The streetwise had a higher ride height than the basic 25, and although it shared many of the common characteristics of the 25, it was visually different with large impact absorbing grey or black plastic bumpers. The Streetwise engines were available as 1.4, 1.6, 1.8 stepspeed (Automatic), and a 2.0 TD. The 1.6 & 1.8 were less common. The car was marketed by Rover as an 'urban on-roader'. Production ended in April 2005, due to the bankruptcy of MG Rover, but reappeared in 2008 in China as the MG 3 SW, following the purchase of MG Rover's assets by Nanjing Automobile Group.Rover Streetwise FAQ's
How do I adjust the headlights on my Rover Streetwise?
To adjust the headlights on your Rover Streetwise, park the vehicle on a level surface facing a wall or garage door. Turn on the low beam headlights and mark the horizontal and vertical centerlines of each beam on the wall using tape or chalk. Locate the headlight adjustment screws, usually positioned on the back or top of the headlight assembly. Adjust the screws, following the manufacturer's instructions, to align the beams with the marked centerlines. Ensure the headlights are properly adjusted to improve visibility and prevent blinding oncoming drivers.
How do I change the oil in my Rover Streetwise?
To change the oil in your Rover Streetwise, first, locate the oil drain plug underneath the vehicle and position an oil pan beneath it. Remove the drain plug and allow the old oil to fully drain. Once drained, replace the drain plug and proceed to remove the oil filter, ensuring you have a new one to replace it with. Finally, refill the engine with the recommended amount of new oil, using a funnel to avoid spills.
How do I check the engine oil level on my Rover Streetwise?
To check the engine oil level on your Rover Streetwise, park the vehicle on a level surface and ensure the engine has been turned off for at least 10 minutes to allow the oil to settle. Open the hood and locate the dipstick, usually labeled "Engine Oil." Pull out the dipstick, wipe it clean with a cloth, and reinsert it fully. Remove it again and check the oil level, ensuring it falls within the recommended range marked on the dipstick. If the oil level is low, add oil gradually while rechecking the level to avoid overfilling.
How do I check the transmission fluid on my Rover Streetwise?
To check the transmission fluid on your Rover Streetwise, start the engine and let it warm up to operating temperature. Locate the transmission dipstick, usually near the back of the engine compartment. With the engine running, pull out the dipstick, wipe it clean, and then reinsert it. Remove it again and check the fluid level, ensuring it is within the recommended range. If the fluid appears dirty or has a burnt smell, it may be time for a transmission fluid change.
How do I replace a brake light bulb on my Rover Streetwise?
To replace a brake light bulb on your Rover Streetwise, start by opening the trunk or the tailgate and locating the back of the brake light assembly. Remove any covers or panels that may be obstructing access to the bulb. Twist the bulb socket counterclockwise and carefully remove it from the assembly. Replace the old bulb with a new one, making sure it is the correct type and properly seated. Reinsert the bulb socket into the assembly, twist it clockwise to secure it, and test the brake light before closing the trunk or tailgate.
How do I replace a cabin air filter on my Rover Streetwise?
To replace a cabin air filter on your Rover Streetwise, start by locating the cabin air filter housing, usually positioned behind the glove compartment or under the dashboard. Open the housing by removing any retaining clips, screws, or panels. Take out the old cabin air filter, making note of its orientation if necessary. Install the new cabin air filter, ensuring it is properly seated, and reattach the housing securely. Regularly replacing the cabin air filter helps maintain clean and fresh air inside the vehicle and improves the efficiency of the heating and cooling system.
How do I replace a fuse on my Rover Streetwise?
To replace a fuse on your Rover Streetwise, start by locating the fuse box, usually found in the engine compartment or under the dashboard. Refer to the owner's manual or the diagram on the fuse box lid to identify the specific fuse related to the malfunctioning component. Using a fuse puller or a pair of needle-nose pliers, carefully remove the fuse and replace it with a new one of the same rating. It is important to ensure the replacement fuse matches the amperage requirements to avoid electrical issues.
How do I replace a headlight bulb on my Rover Streetwise?
To replace a headlight bulb on your Rover Streetwise, start by opening the hood and locating the back of the headlight assembly. Unplug the electrical connector from the bulb and remove the retaining clip or collar holding the bulb in place. Carefully remove the old bulb and replace it with a new one, ensuring not to touch the glass surface with your bare hands. Reattach the retaining clip or collar, plug in the electrical connector, and test the new bulb before closing the hood.
How do I replace a windshield wiper blade on my Rover Streetwise?
To replace a windshield wiper blade on your Rover Streetwise, start by lifting the wiper arm away from the windshield until it locks in an upright position. Locate the release tab on the wiper blade, usually near the wiper arm connection. Press the release tab and slide the old blade downward to remove it from the arm. Align the new wiper blade with the arm and slide it upward until it clicks into place. Gently lower the wiper arm back onto the windshield and test the new blade for proper operation.
How do I replace the air filter on my Rover Streetwise?
To replace the air filter on your Rover Streetwise, start by locating the air filter housing, usually positioned near the engine. Open the housing by removing the clips or screws that hold it in place and carefully lift out the old air filter. Inspect the housing for any debris and clean it if necessary. Install the new air filter, ensuring it is properly seated, and reattach the housing securely. Regularly replacing the air filter helps maintain efficient engine performance and prolongs the life of your Rover Streetwise.
How do I reset the maintenance light on my Rover Streetwise?
To reset the maintenance light on your Rover Streetwise, insert the key into the ignition and turn it to the "on" position without starting the engine. Press and hold the trip reset button on the instrument cluster or the odometer reset button, depending on the model, until the maintenance light starts flashing or goes out. Release the button and start the engine to confirm that the maintenance light has been successfully reset. If the light persists, consult the owner's manual or seek assistance from a qualified mechanic.
How do I top up the power steering fluid on my Rover Streetwise?
To top up the power steering fluid on your Rover Streetwise, locate the power steering fluid reservoir, usually found near the engine. Clean the area around the reservoir cap to prevent any debris from entering. Unscrew the cap and check the fluid level, ensuring it is between the minimum and maximum marks. If the level is low, add the recommended power steering fluid gradually, using a funnel if necessary. It is crucial not to overfill the reservoir, as it may lead to leaks or system malfunctions.
How often should I change the spark plugs on my Rover Streetwise?
The recommended interval for changing spark plugs on your Rover Streetwise can vary depending on the model and engine type. As a general guideline, it is recommended to replace spark plugs every 30,000 to 50,000 miles or as advised in the owner's manual. Regularly changing spark plugs helps ensure optimal engine performance, fuel efficiency, and smooth operation.
What is the recommended tire pressure for my Rover Streetwise?
The recommended tire pressure for your Rover Streetwise can usually be found on a sticker located on the driver's side door jamb or inside the fuel filler door. It is important to ensure that the tire pressure is within the recommended range to ensure proper handling, fuel efficiency, and tire longevity. If the sticker is missing or illegible, you can refer to the owner's manual or consult a reputable tire shop for the correct tire pressure information.
What type of coolant should I use for my Rover Streetwise?
For your Rover Streetwise, it is recommended to use a coolant that meets the specifications outlined in the owner's manual. Typically, a high-quality ethylene glycol-based coolant mixed with distilled water in a 50:50 ratio is suitable for most Rover Streetwise models. However, it is important to consult the manual or a reputable automotive store to ensure you are using the correct coolant for your specific vehicle.
Get notified for new manuals?
We'll send you a quick email when a new Rover Streetwise manual is added.
There are currently no manuals available for Rover Streetwise at this time.