Volkswagen T3 Kombi Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Volkswagen T3 Kombi
The Volkswagen Type 2 (T3) was the third generation of the Volkswagen Transporter and was marketed under various nameplates worldwide including as the Transporter or Caravelle in Europe, Microbus in South Africa, and as the Vanagon in North and South America. The T3 was manufactured in Germany from 1979 until 1990. There were four general petrol engine variants between 1979 and 1991, with several sub-models. . Available engine options differed between regions. Aftermarket VW specialist Oettinger also offered the WBX6, a six-cylinder version. In contrast to the standard flat-four gasoline engines, all diesel engine options were of an inline configuration.Volkswagen T3 Kombi FAQ's
How do I change the oil in a Volkswagen T3 Kombi?
To change the oil in a Volkswagen T3 Kombi, first locate the oil drain plug underneath the engine. Use a wrench to remove the plug and drain the old oil into a suitable container. Once drained, replace the drain plug and refill the engine with the recommended amount of new oil, as specified in the owner's manual.
How do I check the brake fluid level in a Volkswagen T3 Kombi?
To check the brake fluid level in a Volkswagen T3 Kombi, locate the brake fluid reservoir, which is usually located near the firewall in the engine compartment. Ensure the vehicle is on a level surface, remove the cap from the reservoir, and visually inspect the fluid level. It should be between the minimum and maximum marks. If the level is low, add the recommended brake fluid specified in the owner's manual.
How do I check the tire pressure on a Volkswagen T3 Kombi?
To check the tire pressure on a Volkswagen T3 Kombi, first, ensure that the tires are cold. Locate the tire valve stems and remove the valve caps. Use a tire pressure gauge to measure the pressure in each tire, comparing it to the recommended pressure specified in the owner's manual. If needed, add or release air accordingly.
How do I check the transmission fluid level in a Volkswagen T3 Kombi?
To check the transmission fluid level in a Volkswagen T3 Kombi, start the engine and let it idle for a few minutes to warm up. Locate the transmission dipstick, which is usually labeled and located near the back of the engine compartment. Remove the dipstick, wipe it clean, reinsert it fully, and then remove it again. The fluid level should be within the designated marks on the dipstick. If needed, add the recommended transmission fluid specified in the owner's manual.
How do I jump-start a Volkswagen T3 Kombi?
To jump-start a Volkswagen T3 Kombi, first, ensure that both vehicles are turned off. Connect one end of the positive (red) jumper cable to the positive terminal of the dead battery, and the other end to the positive terminal of the fully charged battery. Connect one end of the negative (black) jumper cable to the negative terminal of the fully charged battery, and the other end to a grounded metal surface in the dead vehicle. Start the engine of the fully charged vehicle, then attempt to start the dead vehicle.
How do I replace a blown fuse in a Volkswagen T3 Kombi?
To replace a blown fuse in a Volkswagen T3 Kombi, locate the fuse box, which is usually located in the engine compartment or underneath the dashboard. Refer to the fuse diagram in the owner's manual to identify the fuse that needs to be replaced. Use a fuse puller or a pair of needle-nose pliers to remove the blown fuse and replace it with a new one of the same amperage.
How do I replace a headlight bulb in a Volkswagen T3 Kombi?
To replace a headlight bulb in a Volkswagen T3 Kombi, open the hood and locate the back of the headlight assembly. Twist and remove the bulb holder from the back of the assembly. Carefully remove the old bulb by disconnecting it from the electrical connector, then insert the new bulb and reconnect the electrical connector. Place the bulb holder back into the headlight assembly and twist it to secure it in place.
How do I replace the cabin air filter in a Volkswagen T3 Kombi?
To replace the cabin air filter in a Volkswagen T3 Kombi, locate the cabin air filter housing, which is usually located behind the glove compartment or under the dashboard. Remove the housing cover by unfastening the clips or screws. Take out the old filter and replace it with a new one, ensuring it is properly aligned. Reinstall the housing cover, making sure it is securely fastened.
How do I replace the serpentine belt in a Volkswagen T3 Kombi?
To replace the serpentine belt in a Volkswagen T3 Kombi, first, locate the belt routing diagram, usually found on a sticker under the hood or in the owner's manual. Using a belt tensioner tool or a wrench, release the tension on the belt by rotating the tensioner in the direction specified by the diagram. Slide the old belt off the pulleys and install the new belt according to the routing diagram. Finally, release the tensioner to apply tension to the new belt.
How do I replace the spark plugs in a Volkswagen T3 Kombi?
To replace the spark plugs in a Volkswagen T3 Kombi, start by locating the spark plug wires or ignition coil packs. Disconnect the wires or coil packs from the spark plugs by gently pulling on them. Use a spark plug socket and a ratchet to remove the old spark plugs. Check the gap on the new spark plugs, as specified in the owner's manual, and install them using the socket and ratchet. Reconnect the spark plug wires or coil packs to the corresponding spark plugs.
How do I replace the windshield wiper blades on a Volkswagen T3 Kombi?
To replace the windshield wiper blades on a Volkswagen T3 Kombi, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade. Depress the tab or button and slide the blade out of the wiper arm. Align the new wiper blade with the arm and push it in until it clicks into place. Gently lower the wiper arm back onto the windshield.
How do I reset the service light on a Volkswagen T3 Kombi?
To reset the service light on a Volkswagen T3 Kombi, first, ensure that the ignition is turned off. Press and hold the trip reset button on the instrument cluster. While holding the button, turn the ignition key to the "on" position without starting the engine. Continue to hold the button until the service indicator light starts flashing or resets, indicating that the service light has been successfully reset.
How do I troubleshoot a malfunctioning power window in a Volkswagen T3 Kombi?
If a power window in a Volkswagen T3 Kombi is not functioning properly, start by checking the fuse related to the power windows in the fuse box. If the fuse is intact, try operating the window from both the driver's control panel and the individual window switch. If the window operates from one of the switches but not the other, the switch may need to be replaced. If the window does not operate at all, there may be a problem with the window motor or regulator, which would require further inspection and potentially replacement by a professional.
How often should I replace the air filter in a Volkswagen T3 Kombi?
The air filter in a Volkswagen T3 Kombi should be replaced according to the maintenance schedule outlined in the owner's manual. Typically, it is recommended to replace the air filter every 15,000 to 30,000 miles or every 1 to 2 years, depending on driving conditions. Regular replacement of the air filter helps maintain engine performance and fuel efficiency.
What type of coolant should I use in a Volkswagen T3 Kombi?
For a Volkswagen T3 Kombi, it is recommended to use a high-quality ethylene glycol-based coolant that meets the specifications outlined in the owner's manual. This type of coolant provides proper protection against freezing, boiling, and corrosion, ensuring optimal performance and longevity of the engine.
Get notified for new manuals?
We'll send you a quick email when a new Volkswagen T3 Kombi manual is added.
There are currently no manuals available for Volkswagen T3 Kombi at this time.