BMW 425 Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
BMW 425
The BMW F32 series is the first generation of the BMW 4 Series range of compact executive cars. It is the successor to the E92 model of the 3 Series range. This model is available with diesel engines with size of 1,995 cc that can produce horse power of 218 PS. The BMW 425 was manufactured by German automobile maker BMW since 2014, coupe and convertible versions of this car were produced. It is manufactured with two transmission styles: 6-speed manual and 8-speed automatic with Streptronic.BMW 425 FAQ's
How do I change the air filter in my BMW 425?
To change the air filter in a BMW 425, first remove the engine cover and locate the air filter housing. Open the housing and remove the old air filter. Clean the housing and install the new air filter, making sure it is properly seated. Finally, reinstall the engine cover.
How do I change the engine oil in my BMW 425?
The engine oil in a BMW 425 can be changed by first warming up the engine, then removing the oil drain plug and allowing the oil to drain into a suitable container. Next, replace the oil filter and install a new drain plug gasket. Finally, add new engine oil to the engine, check the oil level and tighten the oil cap.
How do I check and replace the break pads on my BMW 425?
To check the brake pads on a BMW 425, remove the wheel and inspect the pads for wear. If they are worn, remove the brake caliper and pads, then install new pads and reassemble the brake caliper. Make sure to check the brake fluid level and bleed the brakes if necessary.
How do I replace the alternator in my BMW 425?
Replacing the alternator in a BMW 425 involves removing the negative battery cable, the drive belt, and the electrical connections to the alternator. Remove the mounting bolts and lift out the old alternator. Install the new alternator and reassemble the electrical connections, drive belt, and battery cable.
How do I replace the battery in my BMW 425?
To replace the battery in a BMW 425, first remove the negative battery cable, then the positive cable. Remove the battery hold down bracket and lift out the old battery. Install the new battery and reconnect the cables, then reset the clock and radio settings.
How do I replace the cabin air filter in my BMW 425?
The cabin air filter in a BMW 425 is located behind the glove box. To replace it, open the glove box and remove the glove box stops by pressing inward on the sides. Lower the glove box and remove the filter housing cover. Remove the old filter and install the new one, then reassemble the filter housing cover and glove box.
How do I replace the fuel filter in my BMW 425?
To replace the fuel filter in a BMW 425, first relieve the fuel pressure by disconnecting the fuel pump fuse and running the engine until it stalls. Remove the fuel filter and install the new one, making sure to use the correct orientation. Reassemble the fuel lines and electrical connections, then start the engine and check for leaks.
How do I replace the oxygen sensor in my BMW 425?
Replacing the oxygen sensor in a BMW 425 involves locating the sensor, then disconnecting the electrical connector and unscrewing the old sensor from the exhaust system. Install the new sensor and reconnect the electrical connector, then clear any fault codes and test drive the vehicle to ensure proper operation.
How do I replace the radiator in my BMW 425?
To replace the radiator in a BMW 425, first drain the coolant and disconnect the upper and lower hoses and transmission cooler lines. Remove the fan shroud and fan assembly, then remove the radiator mounting bolts and lift out the old radiator. Install the new radiator and reassemble the fan assembly, shroud, hoses, and cooler lines. Refill the coolant and check for leaks.
How do I replace the serpentine belt in my BMW 425?
Replacing the serpentine belt in a BMW 425 involves releasing the belt tensioner, then removing the old belt and installing the new one. Make sure the belt is routed correctly and re-tension the tensioner. Check the belt tension and alignment, then start the engine and check for proper operation.
How do I replace the spark plugs in my BMW 425?
Replacing the spark plugs in a BMW 425 involves removing the engine cover and ignition coils, then removing the old spark plugs and installing new ones. It is important to torque the new spark plugs to the manufacturer's specifications and reinstall the ignition coils and engine cover.
How do I replace the thermostat in my BMW 425?
Replacing the thermostat in a BMW 425 involves draining the coolant, then removing the thermostat housing and old thermostat. Install the new thermostat and housing gasket, then refill the coolant and check for leaks. It is important to use the correct thermostat for the vehicle's engine.
How do I replace the windshield wiper blades on my BMW 425?
To replace the windshield wiper blades on a BMW 425, lift the wiper arm away from the windshield and depress the release tab on the wiper blade. Slide the blade off the wiper arm and install the new blade, making sure it is securely in place.
What type of engine oil should I use in my BMW 425?
BMW recommends using synthetic engine oil with a viscosity of SAE 0W-20 or SAE 0W-30 for the BMW 425. It is important to use the recommended oil type and viscosity to ensure proper engine lubrication and performance.
Get notified for new manuals?
We'll send you a quick email when a new BMW 425 manual is added.
There are currently no manuals available for BMW 425 at this time.