Corvette C5 2004 Owners Manual PDF | Page 294

Back-Up Lamps
You can access the back-up lamps through the inboard
taillamp opening. See Taillamps and Turn Signal Lamps
on page 5-50.
1. Squeeze the tab on the socket while turning it
counterclockwise to remove it from the assembly.
2. Remove the bulb from the socket.
3. Reverse the steps listed previously with a new bulb.
Replacement Bulbs
Exterior Lamp Bulb Number
High-Beam Headlamp 9005
Low-Beam Headlamp 9006
Back-Up 2057
Rear Stop/Tail and Turn Signal 3057
For any bulb replacements or procedures not listed
here, please consult your dealer.
Windshield Wiper Blade
Replacement
Windshield wiper blades should be inspected each time
maintenance is performed. See “Wiper Blade Check”
under Scheduled Maintenance on page 6-4 for
more information.
Replacement blades come in different types and are
removed in different ways. For the proper type and
length, see Normal Maintenance Replacement Parts
on page 6-13.
It is a good idea to clean or replace the wiper blade
assembly every six months.
Notice: Allowing the wiper blade arm to touch the
windshield when no wiper blade is installed
could damage the windshield. Any damage that
occurs would not be covered by your warranty.
Do not allow the wiper blade arm to touch the
windshield.
5-52

Corvette C5 2004 Owners Manual Summary of Content

Back-Up LampsYou can access the back-up lamps through the inboardtaillamp opening. See Taillamps and Turn Signal Lampson page 5-50.1. Squeeze the tab on the socket while turning itcounterclockwise to remove it from the assembly.2. Remove the bulb from the socket.3. Reverse the steps listed previously with a new bulb.Replacement BulbsExterior Lamp Bulb NumberHigh-Beam Headlamp 9005Low-Beam Headlamp 9006Back-Up 2057Rear Stop/Tail and Turn Signal 3057For any bulb replacements or procedures not listedhere, please consult your dealer.Windshield Wiper BladeReplacementWindshield wiper blades should be inspected each timemaintenance is performed. See Wiper Blade Checkunder Scheduled Maintenance on page 6-4 formore information.Replacement blades come in different types and areremoved in different ways. For the proper type andlength, see Normal Maintenance Replacement Partson page 6-13.It is a good idea to clean or replace the wiper bladeassembly every six months.Notice: Allowing the wiper blade arm to touch thewindshield when no wiper blade is installedcould damage the windshield. Any damage thatoccurs would not be covered by your warranty.Do not allow the wiper blade arm to touch thewindshield.5-52