Corvette C6 2009 Owners Manual PDF | Page 111

3. Locate in the garage, the garage door opener
receiver (motor-head unit). Locate the “Learn”
or “Smart” button. It can usually be found where the
hanging antenna wire is attached to the motor-head
unit and may be a colored button. Press this
button. After pressing this button, complete the
following steps in less than 30 seconds.
4. Immediately return to the vehicle. Press and hold the
Universal Home Remote button that will be used to
control the garage door until the garage door moves.
The indicator light, above the selected button, should
slowly blink. This button may need to be held for up
to 20 seconds.
5. Immediately, within one second, release the button
when the garage door moves. The indicator light
blinks rapidly until programming is complete.
6. Press and release the same button again.
The garage door should move, confirming that
programming is successful and complete.
To program another Rolling Code device such as an
additional garage door opener, a security device,
or home automation device, repeat Steps 1-6, choosing
a different function button in Step 4 than what was
used for the garage door opener.
If these instructions do not work, the garage door
opener is probably a Fixed Code unit. Follow the
Programming instructions that follow for a Fixed Code
garage door opener.
2-47

Corvette C6 2009 Owners Manual Summary of Content

3. Locate in the garage, the garage door openerreceiver (motor-head unit). Locate the Learnor Smart button. It can usually be found where thehanging antenna wire is attached to the motor-headunit and may be a colored button. Press thisbutton. After pressing this button, complete thefollowing steps in less than 30 seconds.4. Immediately return to the vehicle. Press and hold theUniversal Home Remote button that will be used tocontrol the garage door until the garage door moves.The indicator light, above the selected button, shouldslowly blink. This button may need to be held for upto 20 seconds.5. Immediately, within one second, release the buttonwhen the garage door moves. The indicator lightblinks rapidly until programming is complete.6. Press and release the same button again.The garage door should move, conrming thatprogramming is successful and complete.To program another Rolling Code device such as anadditional garage door opener, a security device,or home automation device, repeat Steps 1-6, choosinga different function button in Step 4 than what wasused for the garage door opener.If these instructions do not work, the garage dooropener is probably a Fixed Code unit. Follow theProgramming instructions that follow for a Fixed Codegarage door opener.2-47