Every Manual available online - found by our community and shared for FREE. Enjoy!
Ford Econovan
The Mazda Bongo, also known as Ford Econovan, is a van manufactured by the Japanese manufacturer Mazda since 1966. It has been built with rear-, middle-, as well as front-mounted engines. It also formed the basis for the long running Kia Bongo range. Mazda introduced its small van, the Bongo, in May 1966. It featured a rear-mounted 782 cc water-cooled OHV SA 4-stroke engine driving the rear wheels. The original version has round headlights and no grille; after a facelift the second generation Bongo/E-series had rectangular headlights and a more traditional grille. It was manufactured with both diesel and petrol engines.
Ford Econovan FAQ's
How do I bleed the brakes on my Ford Econovan?
To bleed the brakes on your Ford Econovan, have a helper press the brake pedal while you open the bleed valve on the caliper or wheel cylinder. Allow the old fluid to drain out until new fluid starts to flow. Close the valve and repeat the process on the other wheels. Refill the brake fluid reservoir with new fluid.
How do I change the oil in my Ford Econovan?
Changing the oil in your Ford Econovan is a simple task that should be done every 5,000km or 3 months. To begin, locate the oil filter and oil drain plug underneath the vehicle. Unscrew the oil filter and drain the oil into a container. Replace the filter with a new one, and refill with the recommended type and amount of oil specified in the manual.
How do I check the transmission fluid level in my Ford Econovan?
To check the transmission fluid level in your Ford Econovan, start the engine and let it warm up. Park on level ground and shift through all the gears. Place the transmission in park, and locate the transmission dipstick. Pull it out, and wipe it clean. Reinsert the dipstick and check the level. Add fluid if necessary.
How do I replace the air filter in my Ford Econovan?
To replace the air filter in your Ford Econovan, locate the air filter housing under the hood. Open the housing and remove the old filter. Clean the housing and replace the filter with a new one. Make sure the filter is securely in place before closing the housing.
How do I replace the alternator in my Ford Econovan?
To replace the alternator in your Ford Econovan, disconnect the battery and remove the serpentine belt. Remove the wiring and bolts that hold the alternator in place. Replace the old alternator with a new one and reattach the wiring and bolts. Finally, reinstall the serpentine belt and reconnect the battery.
How do I replace the fuel filter in my Ford Econovan?
To replace the fuel filter in your Ford Econovan, locate the filter under the vehicle. Remove the fuel lines and mounting bracket. Take out the old filter and replace it with a new one. Reinstall the mounting bracket and fuel lines.
How do I replace the power steering pump in my Ford Econovan?
To replace the power steering pump in your Ford Econovan, remove the serpentine belt and disconnect the hoses and wiring from the pump. Remove the bolts that hold the pump in place and remove the old pump. Replace it with a new pump and reattach the hoses, wiring, and bolts. Finally, reinstall the serpentine belt.
How do I replace the spark plugs in my Ford Econovan?
To replace the spark plugs in your Ford Econovan, locate the spark plugs and remove them using a spark plug socket. Check the gap on the new spark plugs and adjust if necessary. Install the new spark plugs and torque to the recommended specifications.
How do I replace the starter in my Ford Econovan?
To replace the starter in your Ford Econovan, disconnect the battery and remove the wiring and bolts that hold the starter in place. Remove the old starter and replace it with a new one. Reattach the wiring and bolts and then reconnect the battery.
How do I replace the thermostat in my Ford Econovan?
To replace the thermostat in your Ford Econovan, locate the thermostat housing. Remove the housing and take out the old thermostat. Clean the housing and install the new thermostat. Reinstall the housing and fill the coolant system with new coolant.
How do I replace the timing belt in my Ford Econovan?
To replace the timing belt in your Ford Econovan, remove the engine cover and accessory belts. Remove the timing belt cover and inspect the timing belt for wear and tear. If it needs to be replaced, align the timing marks and remove the old belt. Install the new belt and reassemble the timing belt cover, accessory belts, and engine cover.
How do I replace the water pump in my Ford Econovan?
To replace the water pump in your Ford Econovan, drain the coolant from the system. Remove the serpentine belt and alternator. Remove the water pump pulley and then the water pump. Replace the old water pump with a new one and reattach the pulley, alternator, and serpentine belt. Refill the coolant system with new coolant.
How often should I replace the brake pads on my Ford Econovan?
Brake pads on your Ford Econovan should be replaced every 25,000-50,000km or as soon as you hear a grinding or squeaking noise when you apply the brakes. To replace the brake pads, remove the wheel and caliper, then take out the old pads. Replace them with new pads and reassemble the caliper and wheel.
What should I do if my Ford Econovan is overheating?
If your Ford Econovan is overheating, the first step is to turn off the engine and let it cool down. Check the coolant level and add more if necessary. If the coolant level is fine, check the radiator for any blockages or leaks. If the radiator is blocked or leaking, it may need to be repaired or replaced.
What should I do if my Ford Econovan won’t start?
If your Ford Econovan won’t start, check the battery for a charge. If the battery is fine, check the starter, ignition switch, and fuel pump. If any of these are not working, they may need to be repaired or replaced.
Get notified for new manuals?
We'll send you a quick email when a new Ford Econovan manual is added.