2009 Ford Edge Owners Manual PDF | Page 61

Map/dome lamp (if equipped)
The dome lamp lights when:
? any door is opened,
? the instrument panel dimmer
switch is rotated up until the
courtesy lamps come on, and
? any of the remote entry controls
are pressed and the ignition is
off.
The map lamps are activated by pressing the controls on either side of
the lens.
Rear courtesy lamp
Located in the rear cargo area, the
courtesy lamp lights when:
? any door is opened.
? any of the remote entry controls
are pressed and the ignition is
off.
BULB REPLACEMENT
Lamp assembly condensation
Exterior lamps are vented to accommodate normal changes in pressure.
Condensation can be a natural by-product of this design. When moist air
enters the lamp assembly through the vents, there is a possibility that
condensation can occur when the temperature is cold. When normal
condensation occurs, a thin film of mist can form on the interior of the
lens. The thin mist eventually clears and exits through the vents during
normal operation. Clearing time may take as long as 48 hours under dry
weather conditions.
Examples of acceptable condensation are:
? Presence of thin mist (no streaks, drip marks or droplets)
? Fine mist covers less than 50% of the lens
Lights
61
2009 Edge (edg)
Owners Guide, 3rd Printing
USA (fus)

2009 Ford Edge Owners Manual Summary of Content

Map/dome lamp (if equipped)The dome lamp lights when: any door is opened, the instrument panel dimmerswitch is rotated up until thecourtesy lamps come on, and any of the remote entry controlsare pressed and the ignition isoff.The map lamps are activated by pressing the controls on either side ofthe lens.Rear courtesy lampLocated in the rear cargo area, thecourtesy lamp lights when: any door is opened. any of the remote entry controlsare pressed and the ignition isoff.BULB REPLACEMENTLamp assembly condensationExterior lamps are vented to accommodate normal changes in pressure.Condensation can be a natural by-product of this design. When moist airenters the lamp assembly through the vents, there is a possibility thatcondensation can occur when the temperature is cold. When normalcondensation occurs, a thin film of mist can form on the interior of thelens. The thin mist eventually clears and exits through the vents duringnormal operation. Clearing time may take as long as 48 hours under dryweather conditions.Examples of acceptable condensation are: Presence of thin mist (no streaks, drip marks or droplets) Fine mist covers less than 50% of the lensLights612009 Edge (edg)Owners Guide, 3rd PrintingUSA (fus)