2009 GMC Canyon Owners Manual PDF | Page 300

Windshield Wiper Blade
Replacement
Windshield wiper blades should be inspected for wear
and cracking. See Scheduled Maintenance on page 6-4
for more information.
Replacement blades come in different types and are
removed in different ways. For proper type and length,
see Maintenance Replacement Parts on page 6-14.
Allowing the wiper blade arm to touch the windshield
when no wiper blade is installed could damage the
windshield. Any damage that occurs would not
be covered by your warranty. Do not allow the wiper
blade arm to touch the windshield.
1. To remove the old wiper blades, lift the wiper arm
until it locks into a vertical position.
A. Blade Assembly
B. Arm Assembly
C. Locking Tab
D. Blade Pivot
E. Hook Slot
F. Arm Hook
2. Press down on the blade assembly pivot locking tab.
Pull down on the blade assembly to release it from
the wiper arm hook.
3. Remove the insert from the blade assembly. The
insert has two notches at one end that are locked by
bottom claws of the blade assembly. At the notched
end, pull the insert from the blade assembly.
5-52

Summary of Content

Windshield Wiper BladeReplacementWindshield wiper blades should be inspected for wearand cracking. See Scheduled Maintenance on page 6-4for more information.Replacement blades come in different types and areremoved in different ways. For proper type and length,see Maintenance Replacement Parts on page 6-14.Allowing the wiper blade arm to touch the windshieldwhen no wiper blade is installed could damage thewindshield. Any damage that occurs would notbe covered by your warranty. Do not allow the wiperblade arm to touch the windshield.1. To remove the old wiper blades, lift the wiper armuntil it locks into a vertical position.A. Blade AssemblyB. Arm AssemblyC. Locking TabD. Blade PivotE. Hook SlotF. Arm Hook2. Press down on the blade assembly pivot locking tab.Pull down on the blade assembly to release it fromthe wiper arm hook.3. Remove the insert from the blade assembly. Theinsert has two notches at one end that are locked bybottom claws of the blade assembly. At the notchedend, pull the insert from the blade assembly.5-52