2005 GMC Savana Owners Manual PDF | Page 281

To disconnect the jumper cables from both vehicles, do
the following:
1. Disconnect the black negative (?) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative (?) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the other
vehicle.
5. Return the remote positive (+) terminal cover to its
original position.
All-Wheel Drive
Lubricant checks in this section also apply to these
vehicles. However, there are two additional systems that
need lubrication.
Transfer Case
When to Check Lubricant
Refer to the Maintenance Schedule to determine
how often to check the lubricant. See Scheduled
Maintenance on page 6-4.
How to Check Lubricant
To get an accurate reading, the vehicle should be on a
level surface.
If the level is below the bottom of the ?ller plug hole,
you?ll need to add some lubricant. Add enough lubricant
to raise the level to the bottom of the ?ller plug hole.
Use care not to overtighten the plug.
What to Use
Refer to the Maintenance Schedule to determine what
kind of lubricant to use. See Recommended Fluids
and Lubricants on page 6-13.
5-43

Summary of Content

To disconnect the jumper cables from both vehicles, dothe following:1. Disconnect the black negative () cable from thevehicle that had the dead battery.2. Disconnect the black negative () cable from thevehicle with the good battery.3. Disconnect the red positive (+) cable from thevehicle with the good battery.4. Disconnect the red positive (+) cable from the othervehicle.5. Return the remote positive (+) terminal cover to itsoriginal position.All-Wheel DriveLubricant checks in this section also apply to thesevehicles. However, there are two additional systems thatneed lubrication.Transfer CaseWhen to Check LubricantRefer to the Maintenance Schedule to determinehow often to check the lubricant. See ScheduledMaintenance on page 6-4.How to Check LubricantTo get an accurate reading, the vehicle should be on alevel surface.If the level is below the bottom of the ller plug hole,youll need to add some lubricant. Add enough lubricantto raise the level to the bottom of the ller plug hole.Use care not to overtighten the plug.What to UseRefer to the Maintenance Schedule to determine whatkind of lubricant to use. See Recommended Fluidsand Lubricants on page 6-13.5-43