DIAGNOSIS SYSTEM (BCM)
INL-11
< FUNCTION DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
INL
N
O
P
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : Diagnosis Description INFOID:0000000004223698
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
COMMON ITEM : CONSULT-III Function INFOID:0000000004223699
ECU IDENTIFICATION
Displays the BCM part No.
SELF-DIAG RESULT
Refer to INL-90, "DTC Index".
INT LAMP
Diagnosis mode Function Description
WORK SUPPORT Changes the setting for each system function.
SELF-DIAG RESULTS Displays the diagnosis results judged by BCM.
CAN DIAG SUPPORT MNTR Monitors the reception status of CAN communication viewed from BCM.
DATA MONITOR The BCM input/output signals are displayed.
ACTIVE TEST The signals used to activate each device are forcibly supplied from BCM.
ECU IDENTIFICATION The BCM part number is displayed.
CONFIGURATION This function is not used even though it is displayed.
System Sub system selection item
Diagnosis mode
WORK SUPPORT DATA MONITOR ACTIVE TEST
Door lock DOOR LOCK
Rear window defogger REAR DEFOGGER
Warning chime BUZZER
Interior room lamp timer INT LAMP
Exterior lamp HEADLAMP
Wiper and washer WIPER
Turn signal and hazard warning lamps FLASHER
Air conditioner AIR CONDITONER
Intelligent Key system INTELLIGENT KEY
Combination switch COMB SW
BCM BCM
Immobilizer IMMU
Interior room lamp battery saver BATTERY SAVER
Trunk open TRUNK
Vehicle security system THEFT ALM
RAP system RETAINED PWR
Signal buffer system SIGNAL BUFFER
TPMS AIR PRESSURE MONITOR
Revision: October 2008
2009 Maxima