Honda CRV Repair Manual 1997 2002 (1) PDF | Page 11

????
=LQF?SODWHG?6WHHO?3 ODWH?5HSDLU?
The zinc-plated steel plate used in some panels of the CR-V requires different repair techniques than ordinary steel plate.
Refer to "Body Construction" (see page 1-9) for the location of the zinc-plated panels.
?? Before spot welding the zinc-plated steel plate, remove the paint from both sides of the flange to be welded. Apply
sealer to the flange after welding.
NOTE: Seal the sanded surfaces thoroughly to prevent rust.
?? The electric continuity properties of zinc-plated steel plate is different from ordinary steel plate. When spot
welding, increase the current by 10-20%, or increase the resistance welding time. Also increase the number of
weld spots by 10-20%.
NOTE: The MIG welding procedures for zinc-plated steel plate are the same as for ordinary steel plate.
?? Before applying putty or body filler to the zinc-plated steel plate, sand the zinc plating thoroughly to promote
adhesion and to prevent blistering.
NOTE: Use only epoxy-based putties and fillers on zinc-plated steel plate, following the manufacturer?s specifications.
?? When performing paint work, protect the ground wire and ground wire mounting hole threads with a bolt or a plug.
:$51,1*
To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting, or grinding.
:$51,1*
To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.

Honda CRV Repair Manual 1997 2002 (1) Summary of Content

=LQFSODWHG6WHHO3 ODWH5HSDLUThe zinc-plated steel plate used in some panels of the CR-V requires different repair techniques than ordinary steel plate. Refer to "Body Construction" (see page 1-9) for the location of the zinc-plated panels. Before spot welding the zinc-plated steel plate, remove the paint from both sides of the flange to be welded. Apply sealer to the flange after welding.NOTE: Seal the sanded surfaces thoroughly to prevent rust. The electric continuity properties of zinc-plated steel plate is different from ordinary steel plate. When spot welding, increase the current by 10-20%, or increase the resistance welding time. Also increase the number of weld spots by 10-20%. NOTE: The MIG welding procedures for zinc-plated steel plate are the same as for ordinary steel plate. Before applying putty or body filler to the zinc-plated steel plate, sand the zinc plating thoroughly to promote adhesion and to prevent blistering.NOTE: Use only epoxy-based putties and fillers on zinc-plated steel plate, following the manufacturers specifications. When performing paint work, protect the ground wire and ground wire mounting hole threads with a bolt or a plug.:$51,1*To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting, or grinding.:$51,1*To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.