Jaguar XK 1996 Misc. Document Damaged Wiring Harness PDF

Date of issue 5/96 Bulletin Number 15-35 Page 1 of 1
DATE
15-35
5/96Sedan Range
SERSER
SERSER
SER
VICEVICE
VICEVICE
VICE
TECHNICTECHNIC
TECHNICTECHNIC
TECHNIC
AL BULLETINAL BULLETIN
AL BULLETINAL BULLETIN
AL BULLETIN
1995-96 MY
Sedan Range
720001-770946
MODEL
VIN
Damaged Wiring Harness – Possible
Intermittent Engine Misfire/No Start –
Remove Harness Clip
ISSUE:ISSUE:
ISSUE:ISSUE:
ISSUE:
Some Sedan Range vehicles within the above VIN range may exhibit a condition
of engine misfire/no start, which can be caused by a clip shorting the engine
management harness to ground. The clip, which is located on the bulkhead on the
right side of the engine compartment (Illustration 1), may cut into the harness
causing a short circuit.
ILLUSTRATION 1
HARNESS CLIPHARNESS CLIP
HARNESS CLIPHARNESS CLIP
HARNESS CLIP
HARNESS CLIPHARNESS CLIP
HARNESS CLIPHARNESS CLIP
HARNESS CLIP
The clip is not found in this location on all vehicles and was deleted from the
vehicle build specification after VIN 770946.
ACTION:ACTION:
ACTION:ACTION:
ACTION:
Remove and discard the clip on all vehicles where it is found, to eliminate the
possibility of it penetrating the harness.
In case of a customer complaint of engine misfire/no start, check if the clip is
present and if it has penetrated the harness. Remove and discard the clip. Test to
verify if the harness has been damaged and repair as needed.
JSI-2707
AREA OF POSSIBLE DAMAGEAREA OF POSSIBLE DAMAGE
AREA OF POSSIBLE DAMAGEAREA OF POSSIBLE DAMAGE
AREA OF POSSIBLE DAMAGE
BULKHEADBULKHEAD
BULKHEADBULKHEAD
BULKHEAD