Jeep Grand Cherokee 2007 Workshop Manual PDF | Page 18

4. Insert a blank Sentry Key into the ignition switch and
turn the ignition switch ON within 60 seconds. After 10
seconds, a single chime will sound. The SKIM indicator
light will stop flashing, turn on for 3 seconds; then turn
off.
The new Sentry Key has been programmed. Repeat this
process to program up to a total of 8 keys.
General Information
The Sentry Key Immobilizer System complies with FCC
rules part 15 and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be
received, including interference that may cause undes-
ired operation.
SECURITY ALARM SYSTEM IF EQUIPPED
This system monitors the vehicle doors, liftgate, liftgate
flipper glass, and ignition for unauthorized operation
and movement inside of the vehicle. When the alarm is
activated, the system provides both audible and visual
signals. The horn will sound repeatedly for three minutes
and the headlights and taillights will flash for an addi-
tional 15 minutes.
To Set the Alarm
The alarm will set when you use the remote keyless entry
transmitter to lock the doors and liftgate or when you use
the power door lock switch while the door is open. After
all the doors are locked and closed, a red light (located in
the instrument cluster) will flash rapidly for about 16
seconds to signal that the system is arming. During this
16 second pre-arm period, opening any door or the
liftgate will cancel the arming. If the system successfully
arms, the red light will flash at a slower rate to indicate
the alarm is set. A manual lock of the doors, either with
18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Summary of Content

4. Insert a blank Sentry Key into the ignition switch andturn the ignition switch ON within 60 seconds. After 10seconds, a single chime will sound. The SKIM indicatorlight will stop flashing, turn on for 3 seconds; then turnoff.The new Sentry Key has been programmed. Repeat thisprocess to program up to a total of 8 keys.General InformationThe Sentry Key Immobilizer System complies with FCCrules part 15 and with RSS-210 of Industry Canada.Operation is subject to the following two conditions:1. This device may not cause harmful interference.2. This device must accept any interference that may bereceived, including interference that may cause undes-ired operation.SECURITY ALARM SYSTEM IF EQUIPPEDThis system monitors the vehicle doors, liftgate, liftgateflipper glass, and ignition for unauthorized operationand movement inside of the vehicle. When the alarm isactivated, the system provides both audible and visualsignals. The horn will sound repeatedly for three minutesand the headlights and taillights will flash for an addi-tional 15 minutes.To Set the AlarmThe alarm will set when you use the remote keyless entrytransmitter to lock the doors and liftgate or when you usethe power door lock switch while the door is open. Afterall the doors are locked and closed, a red light (located inthe instrument cluster) will flash rapidly for about 16seconds to signal that the system is arming. During this16 second pre-arm period, opening any door or theliftgate will cancel the arming. If the system successfullyarms, the red light will flash at a slower rate to indicatethe alarm is set. A manual lock of the doors, either with18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE