Jeep Grand Cherokee XJ Workshop Manual 1997 PDF

LUBRICATION AND MAINTENANCE
CONTENTS
page page
GENERAL INFORMATION ................... 1
JUMP STARTING, TOWING AND HOISTING .... 9
MAINTENANCE SCHEDULES ................ 4
GENERAL INFORMATION
INDEX
page page
GENERAL INFORMATION
CLASSIFICATION OF LUBRICANTS ........... 2
FLUID CAPACITIES ....................... 3
INTERNATIONAL SYMBOLS ................ 1
INTRODUCTION ......................... 1
PARTS AND LUBRICANT
RECOMMENDATIONS .................... 1
GENERAL INFORMATION
INTRODUCTION
Service and maintenance procedures for compo-
nents and systems listed in Schedule ?A? or ?B? can
be found by using the Group Tab Locator index at
the front of this manual. If it is not clear which
group contains the information needed, refer to the
index at the back of this manual.
There are two maintenance schedules that show
proper service based on the conditions that the vehi-
cle is subjected to.
Schedule ?A? , lists scheduled maintenance to be
performed when the vehicle is used for general trans-
portation.
Schedule ?B? , lists maintenance intervals for vehi-
cles that are operated under the conditions listed at
the beginning of the Maintenance Schedule section.
Use the schedule that best describes your driving
conditions.
Where time and mileage are listed, follow the
interval that occurs first.
PARTS AND LUBRICANT RECOMMENDATIONS
When service is required, Chrysler Corporation
recommends that only Mopar? brand parts, lubri-
cants and chemicals be used. Mopar provides the
best engineered products for servicing Chrysler Cor-
poration vehicles.
INTERNATIONAL SYMBOLS
Chrysler Corporation uses international symbols to
identify engine compartment lubricant and fluid
inspection and fill locations (Fig. 1).
Fig. 1 International Symbols
XJ LUBRICATION AND MAINTENANCE 0 - 1