Mini Cooper S Countryman 2016 Owners Manual PDF | Page 179

Side marker lights
To replace these bulbs, contact a dealer’s serv‐
ice center or another qualified service center or
repair shop.
Tail lights, bulb replacement
Follow the general instructions on lamps and
bulbs, refer to page 175.
Turn signal: 21-watt bulb, PY 21 W
MINI Countryman
1 Brake/tail light
2 Turn signal
3 Brake/tail light
4 Backup light
MINI Paceman
1 Brake light
2 Tail light
3 Turn signal
4 Backup light
Replacing
All bulbs are integrated in a central bulb holder.
MINI Countryman
1. Switch off the lights and take the remote
control out of the ignition lock.
2. Open the tailgate.
3. Press the cover out of the cargo area side
panel at the rear and remove it.
4. Detach the emergency release of the fuel
filler flap, refer to page 150, and push it
aside with the foam insert.
Ensure that the emergency release is not
damaged.
5. Disengage the bulb holder by pushing
down the clip, arrow 1.
6. Take out the bulb holder and detach the
cable, arrow 2.
7. Apply gentle pressure to the bulb while
turning it to the left and remove it.
8. Insert the new bulb and mount the bulb
holder in reverse order. Ensure that the
bulb holder engages in all fasteners.
Seite 179
Replacing components
MOBILITY
179
Online Edition for Part no. 01 40 2 964 433 - VI/15

Summary of Content

Side marker lightsTo replace these bulbs, contact a dealers service center or another qualified service center orrepair shop.Tail lights, bulb replacementFollow the general instructions on lamps andbulbs, refer to page 175.Turn signal: 21-watt bulb, PY 21 WMINI Countryman1 Brake/tail light2 Turn signal3 Brake/tail light4 Backup lightMINI Paceman1 Brake light2 Tail light3 Turn signal4 Backup lightReplacingAll bulbs are integrated in a central bulb holder.MINI Countryman1. Switch off the lights and take the remotecontrol out of the ignition lock.2. Open the tailgate.3. Press the cover out of the cargo area sidepanel at the rear and remove it.4. Detach the emergency release of the fuelfiller flap, refer to page 150, and push itaside with the foam insert.Ensure that the emergency release is notdamaged.5. Disengage the bulb holder by pushingdown the clip, arrow 1.6. Take out the bulb holder and detach thecable, arrow 2.7. Apply gentle pressure to the bulb whileturning it to the left and remove it.8. Insert the new bulb and mount the bulbholder in reverse order. Ensure that thebulb holder engages in all fasteners.Seite 179Replacing componentsMOBILITY179Online Edition for Part no. 01 40 2 964 433 - VI/15