Nissan 350Z Workshop Manual 2003 (1) PDF | Page 2

ACC-2
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM
PFP:18005
Precautions for Battery Service ABS0035X
This vehicle is equipped with the automatic window adjusting function. When a door is opened, the window
automatically lowers slightly to avoid contact between the window and the side roof panel. After the door is
closed, the window will automatically raise slightly.
On vehicles equipped with the automatic window adjusting function, lower both the driver and front passenger
side windows before disconnecting the battery cables. This will prevent interference between the side window
and the roof panel when either door is opened/closed.
CAUTION:
After the battery cables are disconnected, do not open/close the driver and/or front passenger door
with the window in the full up position. The automatic window adjusting function will not work and the
side roof panel may be damaged.
Removal and Installation ABS0029K
REMOVAL
1. Remove accelerator pedal position sensor harness connector.
2. Loosen nuts, and remove accelerator pedal assembly.
CAUTION:
? Do not disassemble the accelerator pedal assembly. Do not remove the accelerator pedal posi-
tion sensor from the accelerator pedal assembly.
? Avoid impact from dropping etc. during handling.
? Be careful to keep the accelerator pedal assembly away from water.
INSTALLATION
Install in the reverse order of removal.
SBIA0332E
1. Accelerator pedal assembly

Summary of Content

ACC-2ACCELERATOR CONTROL SYSTEMACCELERATOR CONTROL SYSTEMPFP:18005Precautions for Battery Service ABS0035XThis vehicle is equipped with the automatic window adjusting function. When a door is opened, the windowautomatically lowers slightly to avoid contact between the window and the side roof panel. After the door isclosed, the window will automatically raise slightly.On vehicles equipped with the automatic window adjusting function, lower both the driver and front passengerside windows before disconnecting the battery cables. This will prevent interference between the side windowand the roof panel when either door is opened/closed.CAUTION:After the battery cables are disconnected, do not open/close the driver and/or front passenger doorwith the window in the full up position. The automatic window adjusting function will not work and theside roof panel may be damaged.Removal and Installation ABS0029KREMOVAL1. Remove accelerator pedal position sensor harness connector.2. Loosen nuts, and remove accelerator pedal assembly.CAUTION: Do not disassemble the accelerator pedal assembly. Do not remove the accelerator pedal posi-tion sensor from the accelerator pedal assembly. Avoid impact from dropping etc. during handling. Be careful to keep the accelerator pedal assembly away from water.INSTALLATIONInstall in the reverse order of removal.SBIA0332E1. Accelerator pedal assembly