Nissan 350Z Workshop Manual 2003 (40) PDF | Page 23

SEAT
SE-23
C
D
E
F
G
H
J
K
L
M
A
B
SE
SEAT CUSHION TRIM AND PAD (POWER SEAT)
1. Hang snap ring on wire, and pull it up to remove. Remove thigh
support adjuster dial.
2. Unfasten the screw and metal clip and remove the seat cushion
outer finisher.
3. Unfasten screws and remove the power seat switch. (For driver
seat)
Insert a screwdriver in lower side of power seat switch and
remove it. (For passenger seat)
4. Remove bolts on the under side of seat cushion.
5. Remove hog rings from under seat cushion frame. Disconnect harness connector from seat cushion
heater unit.
6. After removing the seat cushion trim and pad, remove the hog rings to separate the trim and pad.
NOTE:
Seat cushion heater unit is stitched into seat cushion trim. It cannot be separated.
PIIA2520E
PIIA2521E
PIIA2522E
PIIA2930E