Nissan 350Z Workshop Manual 2003 (9) PDF | Page 21

TROUBLE DIAGNOSIS
BRC-21
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Note 1: Confirm tire pressure is normal.
Note 2: ABS warning lamp ON/OFF timing
ON: For approximately 1 second after the ignition switch is turned on or when an error is detected.
OFF: Approximately 1 second after the ignition switch is turned on (when system is normal).
CONSULT- II Functions AFS0011A
CAUTION:
? Do not use the ?function test? for diagnosis. For more information, refer to the separate volume
?CONSULT-II OPERATION MANUAL (Function Test)?.
? When communicating with CONSULT-II, the ABS warning lamp are on.
? When TCS conducts a self-diagnosis, data monitoring, or executes the active test function, EBD,
ABS, and TCS control are not conducted.
? When a self-diagnosis, active test, work support, etc., ABS control unit is conducted using CON-
SULT-II, stop engine temporarily and connect CONSULT-II and then select ?ABS?.
? CONSULT-II self-diagnosis results are displayed without regard to occurrence timing. In some
cases later ones (timing value is small) appear on the next screen.
CONSULT-II FUNCTION APPLICATION TABLE (MAIN ITEMS)
: Applicable
?: Not applicable
Items Self-diagnosis Data monitor Active test
FR RH WHEEL SENSOR ?
FR LH WHEEL SENSOR ?
RR RH WHEEL SENSOR ?
RR LH WHEEL SENSOR ?
Stop lamp switch ?
FR RH IN ABS SOL
FR RH OUT ABS SOL
FR LH IN ABS SOL
FR LH OUT ABS SOL
RR RH IN ABS SOL
RR RH OUT ABS SOL
RR LH IN ABS SOL
RR LH OUT ABS SOL
ABS ACTUATOR RELAY ?
ABS motor relay ?
ABS warning lamp ? ?
Battery voltage ?
ABS C/U ??
ABS motor
CAN communication ?
Engine speed signal ? ?
Gear ? ?

Summary of Content

TROUBLE DIAGNOSISBRC-21[ABS]CDEGHIJKLMABBRCNote 1: Confirm tire pressure is normal.Note 2: ABS warning lamp ON/OFF timing ON: For approximately 1 second after the ignition switch is turned on or when an error is detected.OFF: Approximately 1 second after the ignition switch is turned on (when system is normal).CONSULT- II Functions AFS0011ACAUTION: Do not use the function test for diagnosis. For more information, refer to the separate volumeCONSULT-II OPERATION MANUAL (Function Test). When communicating with CONSULT-II, the ABS warning lamp are on. When TCS conducts a self-diagnosis, data monitoring, or executes the active test function, EBD,ABS, and TCS control are not conducted. When a self-diagnosis, active test, work support, etc., ABS control unit is conducted using CON-SULT-II, stop engine temporarily and connect CONSULT-II and then select ABS. CONSULT-II self-diagnosis results are displayed without regard to occurrence timing. In somecases later ones (timing value is small) appear on the next screen.CONSULT-II FUNCTION APPLICATION TABLE (MAIN ITEMS): Applicable: Not applicableItems Self-diagnosis Data monitor Active testFR RH WHEEL SENSOR FR LH WHEEL SENSOR RR RH WHEEL SENSOR RR LH WHEEL SENSOR Stop lamp switch FR RH IN ABS SOL FR RH OUT ABS SOL FR LH IN ABS SOL FR LH OUT ABS SOL RR RH IN ABS SOL RR RH OUT ABS SOL RR LH IN ABS SOL RR LH OUT ABS SOL ABS ACTUATOR RELAY ABS motor relay ABS warning lamp Battery voltage ABS C/U ABS motor CAN communication Engine speed signal Gear