Nissan 350Z Workshop Manual 2003 (9) PDF | Page 42

BRC-42
[ABS]
SENSOR ROTOR
SENSOR ROTOR
PFP:47970
Removal and Installation AFS0011T
REMOVAL
Front
Sensor rotor cannot be disassembled. To replace sensor rotor, replace hub bearing assembly. Refer to FAX-4,
"Removal and Installation" in ?Front Axle/Drive Shaft? in ?FAX? section.
Rear
? Follow procedure below to remove rear sensor rotor.
? Remove side flange. Refer to RFD-8, "SIDE OIL SEAL" in ?Rear Final Drive? in ?RFD? section.
? Using a bearing replacer (special service tool) and puller (commercial service tool), remove sensor rotor
from the companion flange.
INSTALLATION
Front
Sensor rotor cannot be disassembled. To replace sensor rotor, replace hub bearing assembly. Refer to FAX-4,
"Removal and Installation" in ?Front Axle/Drive Shaft? in ?FAX? section.
Rear
? Follow procedure below to install rear sensor rotor.
? Using a drift (special service tool), press rear sensor rotor onto
the side flange.
? Install side flange. Refer to RFD-8, "SIDE OIL SEAL" in ?Rear
Final Drive? in ?RFD? section.
Number of sensor rotor teeth
Rear : 46
BRG1210D