Nissan 350Z Workshop Manual 2003 (9) PDF | Page 66

BRC-66
[TCS/ABS]
TROUBLE DIAGNOSIS
CONSULT-II BASIC OPERATION PROCEDURE
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the
data link connector.
CAUTION:
If CONSULT-II is used with no connection of CONSULT-II
CONVERTER, malfunctions might be detected in self-diag-
nosis depending on control unit which carry out CAN com-
munication.
3. Turn ignition switch ON.
4. Touch ?START (NISSAN BASED VHCL)?.
5. Touch ?ABS? in the ?Diagnosis System Selection? screen.
If ?ABS? is not indicated, go to GI-40, "
CONSULT-II Data Link
Connector (DLC) Circuit" .
6. Select the required diagnostic location from the ?Diagnosis
Mode Selection? screen.
For further information, see the CONSULT-II Operation Manual.
PBIB1069E
SKIA3098E
PKIA2102E
PFIA0310E

Nissan 350Z Workshop Manual 2003 (9) Summary of Content

BRC-66[TCS/ABS]TROUBLE DIAGNOSISCONSULT-II BASIC OPERATION PROCEDURE1. Turn ignition switch OFF.2. Connect CONSULT-II and CONSULT-II CONVERTER to thedata link connector.CAUTION:If CONSULT-II is used with no connection of CONSULT-IICONVERTER, malfunctions might be detected in self-diag-nosis depending on control unit which carry out CAN com-munication.3. Turn ignition switch ON.4. Touch START (NISSAN BASED VHCL).5. Touch ABS in the Diagnosis System Selection screen.If ABS is not indicated, go to GI-40, "CONSULT-II Data LinkConnector (DLC) Circuit" .6. Select the required diagnostic location from the DiagnosisMode Selection screen.For further information, see the CONSULT-II Operation Manual.PBIB1069ESKIA3098EPKIA2102EPFIA0310E