Nissan 350Z Workshop Maunual 2004 (10) PDF | Page 15

CLUTCH DISC, CLUTCH COVER
CL-15
D
E
F
G
H
I
J
K
L
M
A
B
CL
Revision: 2004 December 2004.5 350Z
CLUTCH DISC, CLUTCH COVER PFP:30100
Removal and Installation ACS004N8
CAUTION:
? Be careful not to bring any grease into contact with the clutch disc facing, pressure plate surface,
or flywheel surface.
? If flywheel is removed, align dowel pin with the smallest hole of flywheel. Refer to EM-115,
"ASSEMBLY" .
REMOVAL
1. Remove manual transmission from the vehicle. Refer to MT-19, "Removal and Installation from Vehicle" .
2. Loosen clutch cover mounting bolts with power tool. Remove clutch cover and clutch disc.
INSPECTION AND ADJUSTMENT AFTER REMOVAL
Clutch Disc
? Measure circumference runout relative to the clutch disc center
spline. If it is outside the specification, replace the clutch disc.
? Measure backlash for clutch disc spline and main drive shaft
spline at the circumference of the disc. If it is outside the speci-
fied range, replace the clutch disc.
1. Flywheel 2. Clutch disc 3. Clutch cover
PCIB0686E
Runout limit/diameter of the area to be measured:
0.7 mm (0.028 in) or less/240 mm (9.45 in) dia.
Maximum backlash of spline:
1.0 mm (0.039 in)
SCL221

Summary of Content

CLUTCH DISC, CLUTCH COVERCL-15DEFGHIJKLMABCLRevision: 2004 December 2004.5 350ZCLUTCH DISC, CLUTCH COVER PFP:30100Removal and Installation ACS004N8CAUTION: Be careful not to bring any grease into contact with the clutch disc facing, pressure plate surface,or flywheel surface. If flywheel is removed, align dowel pin with the smallest hole of flywheel. Refer to EM-115,"ASSEMBLY" .REMOVAL1. Remove manual transmission from the vehicle. Refer to MT-19, "Removal and Installation from Vehicle" .2. Loosen clutch cover mounting bolts with power tool. Remove clutch cover and clutch disc.INSPECTION AND ADJUSTMENT AFTER REMOVALClutch Disc Measure circumference runout relative to the clutch disc centerspline. If it is outside the specification, replace the clutch disc. Measure backlash for clutch disc spline and main drive shaftspline at the circumference of the disc. If it is outside the speci-fied range, replace the clutch disc.1. Flywheel 2. Clutch disc 3. Clutch coverPCIB0686ERunout limit/diameter of the area to be measured:0.7 mm (0.028 in) or less/240 mm (9.45 in) dia.Maximum backlash of spline:1.0 mm (0.039 in)SCL221