Nissan 350Z Workshop Maunual 2004 (10) PDF | Page 8

CL-8
CLUTCH MASTER CYLINDER
Revision: 2004 December 2004.5 350Z
CLUTCH MASTER CYLINDER PFP:30610
Removal and Installation ACS004N2
REMOVAL
1. Remove kicking plate. Refer to EI-37, "Removal and Installation (for Roadster Models)" .
2. Remove footrest.Refer to EI-43, "
Removal and Installation" .
3. Remove dash side finisher. Refer to IP-11, "
Removal and Installation" .
4. Remove instrument driver panel lower. Refer to IP-11, "
Removal and Installation" .
5. Remove VDC/TCS/ABS control unit. (VDC/TCS/ABS model) Refer to BRC-144, "
Removal and Installa-
tion" .
6. Remove snap pin and clevis pin from the clevis, and separate it from clutch pedal.
7. Remove clips, and remove hoodledge cover.
8. Drain clutch fluid in the reservoir tank and remove reservoir hose from nipple.
CAUTION:
Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash the
affected area with water.
9. Remove the reservoir tank mounting nuts and then remove the
reservoir tank.
10. Using a flare nut wrench, remove clutch tube.
11. First remove nuts on master cylinder assembly, and then master
cylinder assembly from the vehicle.
INSTALLATION
1. Connect clutch tube to master cylinder assembly and temporarily tighten flare nut.
1. Nipple 2. Clamp 3. Reservoir hose
4. Cylinder body 5. Packing 6. Seat
7. Clevis 8. Clevis pin 9. Snap pin
10. Stopper ring 11. Stopper 12. Push rod
13. Piston assembly 14. Return spring 15. Reservoir seal
16. Spring pin
PCIB0697E
SCIA1587E

Nissan 350Z Workshop Maunual 2004 (10) Summary of Content

CL-8CLUTCH MASTER CYLINDERRevision: 2004 December 2004.5 350ZCLUTCH MASTER CYLINDER PFP:30610Removal and Installation ACS004N2REMOVAL1. Remove kicking plate. Refer to EI-37, "Removal and Installation (for Roadster Models)" .2. Remove footrest.Refer to EI-43, "Removal and Installation" .3. Remove dash side finisher. Refer to IP-11, "Removal and Installation" .4. Remove instrument driver panel lower. Refer to IP-11, "Removal and Installation" .5. Remove VDC/TCS/ABS control unit. (VDC/TCS/ABS model) Refer to BRC-144, "Removal and Installa-tion" .6. Remove snap pin and clevis pin from the clevis, and separate it from clutch pedal.7. Remove clips, and remove hoodledge cover.8. Drain clutch fluid in the reservoir tank and remove reservoir hose from nipple.CAUTION:Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash theaffected area with water.9. Remove the reservoir tank mounting nuts and then remove thereservoir tank.10. Using a flare nut wrench, remove clutch tube.11. First remove nuts on master cylinder assembly, and then mastercylinder assembly from the vehicle.INSTALLATION1. Connect clutch tube to master cylinder assembly and temporarily tighten flare nut.1. Nipple 2. Clamp 3. Reservoir hose4. Cylinder body 5. Packing 6. Seat7. Clevis 8. Clevis pin 9. Snap pin10. Stopper ring 11. Stopper 12. Push rod13. Piston assembly 14. Return spring 15. Reservoir seal16. Spring pinPCIB0697ESCIA1587E