Nissan 350Z Workshop Maunual 2004 (17) PDF | Page 6

FAX-6
FRONT WHEEL HUB AND KNUCKLE
Revision: 2004 December 2004.5 350Z
Axial End Play Inspection
? Move tip of ball joint in axial direction to check for looseness.
? If the value is outside the standard, replace steering knuckle.
INSTALLATION
? Refer to FAX-4, "Removal and Installation" for tightening torque. Install in the reverse order of removal.
NOTE:
Refer to component parts location and do not reuse non-reusable parts.
? Wheel hub and bearing assembly and disc must be installed to
fit the marked position each other.
Standard value
Axial end play : 0 mm (0 in)
SDIA1147E

Nissan 350Z Workshop Maunual 2004 (17) Summary of Content

FAX-6FRONT WHEEL HUB AND KNUCKLERevision: 2004 December 2004.5 350ZAxial End Play Inspection Move tip of ball joint in axial direction to check for looseness. If the value is outside the standard, replace steering knuckle.INSTALLATION Refer to FAX-4, "Removal and Installation" for tightening torque. Install in the reverse order of removal.NOTE:Refer to component parts location and do not reuse non-reusable parts. Wheel hub and bearing assembly and disc must be installed tofit the marked position each other.Standard valueAxial end play : 0 mm (0 in)SDIA1147E