Nissan 350Z Workshop Maunual 2004 (9) PDF | Page 39

SENSOR ROTOR
BRC-39
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Revision: 2004 December 2004.5 350Z
SENSOR ROTOR PFP:47970
Removal and Installation AFS0029M
REMOVAL
Front
Sensor rotor cannot be disassembled. To replace sensor rotor, replace hub bearing assembly. Refer to FAX-4,
"Removal and Installation" in ?Front Axle/Drive Shaft? in ?FAX? section.
Rear
? Follow procedure below to remove rear sensor rotor.
? Remove side flange. Refer to RFD-8, "SIDE OIL SEAL" in ?Rear Final Drive? in ?RFD? section.
? Using a bearing replacer (special service tool) and puller (commercial service tool), remove sensor rotor
from the companion flange.
INSTALLATION
Front
Sensor rotor cannot be disassembled. To replace sensor rotor, replace hub bearing assembly. Refer to FAX-4,
"Removal and Installation" in ?Front Axle/Drive Shaft? in ?FAX? section.
Rear
? Follow procedure below to install rear sensor rotor.
? Using a drift (special service tool), press rear sensor rotor onto
the side flange.
? Install side flange. Refer to RFD-8, "SIDE OIL SEAL" in ?Rear
Final Drive? in ?RFD? section.
BRG1210D