Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 103

CAMSHAFT
EM-103
C
D
E
F
G
H
I
J
K
L
M
A
EM
Revision: 2005 August 2005 350Z
? Refer to GI-10, "Components" for symbol mark in the figure.
REMOVAL
1. Remove front timing chain case, camshaft sprocket, timing chain and rear timing chain case. Refer to EM-
59, "TIMING CHAIN" .
2. Remove camshaft position sensor (PHASE) (right and left
banks) and exhaust valve timing control position sensor (right
and left banks) (only for 35
th
Anniversary) from cylinder head
back side.
CAUTION:
? Handle carefully to avoid dropping and shocks.
? Do not disassemble.
? Do not allow metal powder to adhere to magnetic part at
sensor tip.
? Do not place sensors in a location where they are
exposed to magnetism.
3. Remove intake valve timing control solenoid valves.
? Discard intake valve timing control solenoid valve gaskets and
use new gaskets for installation.
4. Remove intake and exhaust camshaft brackets.
? Mark camshafts, camshaft brackets and bolts so they are placed in the same position and direction for
installation.
19. Camshaft bracket (No. 1) 20. Timing chain tensioner (Secondary) 21. Spring
22. Plunger 23. Cylinder head (left bank) 24.
Camshaft position sensor (PHASE)
(right bank)
25. Camshaft (INT) 26. Camshaft (EXH) 27. Camshaft bracket (No. 2 to No. 4)
28.
Exhaust valve timing control position
sensor (right bank)
29.
Exhaust valve timing control position
sensor (left bank)
A. Refer to EM-107
.B.
Only for 35
th
Anniversary
KBIA1046E
SEM443GA

Nissan 350Z Workshop Maunual 2005 (15) Summary of Content

CAMSHAFTEM-103CDEFGHIJKLMAEMRevision: 2005 August 2005 350Z Refer to GI-10, "Components" for symbol mark in the figure.REMOVAL1. Remove front timing chain case, camshaft sprocket, timing chain and rear timing chain case. Refer to EM-59, "TIMING CHAIN" .2. Remove camshaft position sensor (PHASE) (right and leftbanks) and exhaust valve timing control position sensor (rightand left banks) (only for 35th Anniversary) from cylinder headback side.CAUTION: Handle carefully to avoid dropping and shocks. Do not disassemble. Do not allow metal powder to adhere to magnetic part atsensor tip. Do not place sensors in a location where they areexposed to magnetism.3. Remove intake valve timing control solenoid valves. Discard intake valve timing control solenoid valve gaskets anduse new gaskets for installation.4. Remove intake and exhaust camshaft brackets. Mark camshafts, camshaft brackets and bolts so they are placed in the same position and direction forinstallation.19. Camshaft bracket (No. 1) 20. Timing chain tensioner (Secondary) 21. Spring22. Plunger 23. Cylinder head (left bank) 24.Camshaft position sensor (PHASE) (right bank)25. Camshaft (INT) 26. Camshaft (EXH) 27. Camshaft bracket (No. 2 to No. 4)28.Exhaust valve timing control position sensor (right bank)29.Exhaust valve timing control position sensor (left bank)A. Refer to EM-107 .B.Only for 35th AnniversaryKBIA1046ESEM443GA