Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 15

DRIVE BELTS
EM-15
C
D
E
F
G
H
I
J
K
L
M
A
EM
Revision: 2005 August 2005 350Z
ALTERNATOR AND POWER STEERING OIL PUMP BELT
1. Remove undercover with power tool.
2. Loosen idler pulley lock nut (A) and adjust tension by turning
adjusting bolt (B).
? For specified belt tension, refer to EM-14, "Checking Drive
Belts" .
3. Tighten nut (A).
A/C COMPRESSOR BELT
1. Remove undercover with power tool.
2. Loosen idler pulley lock nut (C) and adjust tension by turning adjusting bolt (D).
? For specified belt tension, refer to EM-14, "Checking Drive Belts" .
3. Tighten nut (C).
Removal and Installation ABS009YE
REMOVAL
1. Remove undercover with power tool.
2. Remove alternator and power steering oil pump belt. Refer to EM-15, "
ALTERNATOR AND POWER
STEERING OIL PUMP BELT" .
3. Remove A/C compressor belt. Refer to EM-15, "
A/C COMPRESSOR BELT" .
CAUTION:
Grease is applied to idler pulley adjusting bolt. Be careful to keep grease away from belt.
INSTALLATION
1. Install belts to pulley in the reverse order of removal.
CAUTION:
? Make sure belt is correctly engaged with the pulley groove.
? Check for engine oil and engine coolant are not adhered belt and each pulley groove.
2. Adjust belt tension. Refer to EM-14, "
Tension Adjustment" .
3. Tighten each nuts and bolts and nut to the specified torque.
4. Make sure that tension of each belt is within the standard.
: 31.4 - 38.2 Nm (3.2 - 3.9 kg-m, 24 - 28 ft-lb)
SBIA0532E
: 30.4 - 39.2 Nm (3.1 - 4.0 kg-m, 23 - 28 ft-lb)