Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 21

INTAKE MANIFOLD COLLECTOR
EM-21
C
D
E
F
G
H
I
J
K
L
M
A
EM
Revision: 2005 August 2005 350Z
INSTALLATION
Note the following, and install in the reverse order of removal.
Part Installation Direction
Referring to front marks, install parts shown in the figure.
Intake Manifold Collector (Lower)
Tighten mounting bolts in numerical order as shown in the figure.
NOTE:
Tighten mounting bolts to secure gasket (lower), intake manifold col-
lector (lower), gasket (upper), and intake manifold collector cover.
Intake Manifold Collector (Upper)
? If stud bolts were removed, install them and tighten to the specified torque below.
? Shank length under bolt head varies with bolt location. Install
mounting bolts while referring to numbers shown below and in
the figure. (Bolt length does not include pilot portion.)
? Tighten mounting bolts in numerical order as shown in the fig-
ure.
Water Hose
? Insert hose by 27 to 32 mm (1.06 to 1.26 in) from connector end.
PBIC0776E
PBIC0774E
: 4.9 - 6.9 Nm (0.5 - 0.7 kg-m, 44 - 61 in-lb)
Bolt
M6 25 mm (0.98 in) : 7, 8, 10, 11, 13, 14, 15, 16, 18
M6 45 mm (1.77 in) : 2, 4, 5
M6 60 mm (2.36 in) : 1, 3, 6, 9
M6 Nut : 12, 17
PBIC1094E

Summary of Content

INTAKE MANIFOLD COLLECTOREM-21CDEFGHIJKLMAEMRevision: 2005 August 2005 350ZINSTALLATIONNote the following, and install in the reverse order of removal.Part Installation DirectionReferring to front marks, install parts shown in the figure.Intake Manifold Collector (Lower)Tighten mounting bolts in numerical order as shown in the figure.NOTE:Tighten mounting bolts to secure gasket (lower), intake manifold col-lector (lower), gasket (upper), and intake manifold collector cover.Intake Manifold Collector (Upper) If stud bolts were removed, install them and tighten to the specified torque below. Shank length under bolt head varies with bolt location. Installmounting bolts while referring to numbers shown below and inthe figure. (Bolt length does not include pilot portion.) Tighten mounting bolts in numerical order as shown in the fig-ure.Water Hose Insert hose by 27 to 32 mm (1.06 to 1.26 in) from connector end.PBIC0776EPBIC0774E: 4.9 - 6.9 Nm (0.5 - 0.7 kg-m, 44 - 61 in-lb)BoltM6 25 mm (0.98 in) : 7, 8, 10, 11, 13, 14, 15, 16, 18M6 45 mm (1.77 in) : 2, 4, 5M6 60 mm (2.36 in) : 1, 3, 6, 9M6 Nut : 12, 17PBIC1094E