Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 22

EM-22
INTAKE MANIFOLD COLLECTOR
Revision: 2005 August 2005 350Z
? Clamp hose at location of 3 to 7 mm (0.12 to 0.28 in) from hose end.
Electric Throttle Control Actuator
? Install gasket with positioning no-protrusion surface upward or downward.
? Tighten mounting bolts in numerical order as shown in the fig-
ure.
? Perform the ?Throttle Valve Closed Position Learning? when har-
ness connector of electric throttle control actuator is discon-
nected. Refer to EC-91, "
Throttle Valve Closed Position
Learning" .
? Perform the ?Idle Air Volume Learning? and ?Throttle Valve
Closed Position Learning? when electric throttle control actuator
is replaced. Refer to EC-92, "
Idle Air Volume Learning" .
KBIA0957E

Summary of Content

EM-22INTAKE MANIFOLD COLLECTORRevision: 2005 August 2005 350Z Clamp hose at location of 3 to 7 mm (0.12 to 0.28 in) from hose end.Electric Throttle Control Actuator Install gasket with positioning no-protrusion surface upward or downward. Tighten mounting bolts in numerical order as shown in the fig-ure. Perform the Throttle Valve Closed Position Learning when har-ness connector of electric throttle control actuator is discon-nected. Refer to EC-91, "Throttle Valve Closed PositionLearning" . Perform the Idle Air Volume Learning and Throttle ValveClosed Position Learning when electric throttle control actuatoris replaced. Refer to EC-92, "Idle Air Volume Learning" .KBIA0957E