Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 24

EM-24
INTAKE MANIFOLD
Revision: 2005 August 2005 350Z
INSTALLATION
Note the following, and install in the reverse order of removal.
Intake Manifold
? If stud bolts were removed, install them and tighten to the specified torque below.
? Tighten all mounting nuts and bolts to the specified torque in two
or more steps in numerical order shown in the figure.
: 9.8 - 11.8 Nm (1.0 - 1.2 kg-m, 87 - 104 in-lb)
1st step
: 4.9 - 9.8 Nm (0.5 - 1.0 kg-m, 4 - 7 ft-lb)
2nd step and after
: 26.5 - 31.4 Nm (2.7 - 3.2 kg-m, 20 - 23 ft-lb)
PBIC0778E

Nissan 350Z Workshop Maunual 2005 (15) Summary of Content

EM-24INTAKE MANIFOLDRevision: 2005 August 2005 350ZINSTALLATIONNote the following, and install in the reverse order of removal.Intake Manifold If stud bolts were removed, install them and tighten to the specified torque below. Tighten all mounting nuts and bolts to the specified torque in twoor more steps in numerical order shown in the figure. : 9.8 - 11.8 Nm (1.0 - 1.2 kg-m, 87 - 104 in-lb) 1st step: 4.9 - 9.8 Nm (0.5 - 1.0 kg-m, 4 - 7 ft-lb) 2nd step and after: 26.5 - 31.4 Nm (2.7 - 3.2 kg-m, 20 - 23 ft-lb)PBIC0778E