Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 31

OIL PAN AND OIL STRAINER
EM-31
C
D
E
F
G
H
I
J
K
L
M
A
EM
Revision: 2005 August 2005 350Z
b. Insert seal cutter [SST] between oil pan (upper) and oil pan
(lower).
CAUTION:
? Be careful not to damage the mating surfaces.
? Do not insert screwdriver, this will damage the mating
surface.
21. Remove baffle plate.
22. Remove oil strainer.
23. Remove transmission joint bolts which pierce oil pan (upper). Refer to MT-18, "
TRANSMISSION ASSEM-
BLY" (M/T models) or AT-272, "TRANSMISSION ASSEMBLY" (A/T models).
24. Remove rear cover plate.
25. Loosen mounting bolts with power tool in reverse order as
shown in the figure to remove oil pan (upper).
? Insert seal cutter [SST: KV10111100 (J37228)] between oil
pan (upper) and cylinder block. Slide seal cutter by tapping on
the side of tool with hammer. Remove oil pan (upper).
CAUTION:
Be careful not to damage mating surface.
26. Remove O-rings from bottom of cylinder block and oil pump.
27. Remove oil pan gaskets.
INSPECTION AFTER REMOVAL
Clean oil strainer if any object attached.
SEM365E
PBIC0783E
PBIC1144E
PBIC1145E

Nissan 350Z Workshop Maunual 2005 (15) Summary of Content

OIL PAN AND OIL STRAINEREM-31CDEFGHIJKLMAEMRevision: 2005 August 2005 350Zb. Insert seal cutter [SST] between oil pan (upper) and oil pan(lower).CAUTION: Be careful not to damage the mating surfaces. Do not insert screwdriver, this will damage the matingsurface.21. Remove baffle plate.22. Remove oil strainer.23. Remove transmission joint bolts which pierce oil pan (upper). Refer to MT-18, "TRANSMISSION ASSEM-BLY" (M/T models) or AT-272, "TRANSMISSION ASSEMBLY" (A/T models).24. Remove rear cover plate.25. Loosen mounting bolts with power tool in reverse order asshown in the figure to remove oil pan (upper). Insert seal cutter [SST: KV10111100 (J37228)] between oilpan (upper) and cylinder block. Slide seal cutter by tapping onthe side of tool with hammer. Remove oil pan (upper).CAUTION:Be careful not to damage mating surface.26. Remove O-rings from bottom of cylinder block and oil pump.27. Remove oil pan gaskets.INSPECTION AFTER REMOVALClean oil strainer if any object attached.SEM365EPBIC0783EPBIC1144EPBIC1145E