Nissan 350Z Workshop Maunual 2005 (15) PDF | Page 32

EM-32
OIL PAN AND OIL STRAINER
Revision: 2005 August 2005 350Z
INSTALLATION
1. Install oil pan (upper) as follows:
a. Use scraper to remove old liquid gasket from mating surfaces.
? Also remove the old liquid gasket from mating surface of cyl-
inder block.
? Remove old liquid gasket from the bolt holes and threads.
CAUTION:
Do not scratch or damage the mating surfaces when clean-
ing off old liquid gasket.
b. Install new oil pan gaskets.
? Apply liquid gasket to oil pan gaskets as shown in the figure.
Use Genuine RTV Silicone Sealant or equivalent. Refer to
GI-47, "
RECOMMENDED CHEMICAL PRODUCTS AND
SEALANTS" .
? To install, align protrusion of oil pan gasket with notches of
front timing chain case and rear oil seal retainer.
? Install oil pan gasket with smaller arc to front timing chain
case side.
c. Install new O-rings on the bottom of cylinder block and oil pump.
MEM108A
PBIC2630E
PBIC1145E
PBIC1144E

Nissan 350Z Workshop Maunual 2005 (15) Summary of Content

EM-32OIL PAN AND OIL STRAINERRevision: 2005 August 2005 350ZINSTALLATION1. Install oil pan (upper) as follows:a. Use scraper to remove old liquid gasket from mating surfaces. Also remove the old liquid gasket from mating surface of cyl-inder block. Remove old liquid gasket from the bolt holes and threads.CAUTION:Do not scratch or damage the mating surfaces when clean-ing off old liquid gasket.b. Install new oil pan gaskets. Apply liquid gasket to oil pan gaskets as shown in the figure.Use Genuine RTV Silicone Sealant or equivalent. Refer toGI-47, "RECOMMENDED CHEMICAL PRODUCTS ANDSEALANTS" . To install, align protrusion of oil pan gasket with notches offront timing chain case and rear oil seal retainer. Install oil pan gasket with smaller arc to front timing chaincase side.c. Install new O-rings on the bottom of cylinder block and oil pump.MEM108APBIC2630EPBIC1145EPBIC1144E