Nissan 350Z Workshop Maunual 2005 (31) PDF | Page 18

PG-18
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
Revision: 2005 August 2005 350Z
CONSULT-II Function (IPDM E/R) AKS00A2L
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
CONSULT-II BASIC OPERATION
CAUTION:
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be
detected in self-diagnosis depending on control unit which carry out CAN communication.
1. With the ignition switch OFF, connect CONSULT-II and CON-
SULT-II CONVERTER to the data link connector, then turn the
ignition switch ON.
2. Touch ?START (NISSAN BASED VHCL)?.
3. Touch ?IPDM E/R? on ?SELECT SYSTEM? screen.
If ?IPDM E/R? is not displayed, refer to GI-39, "
CONSULT-II Data
Link Connector (DLC) Circuit" .
Inspection Item, Diagnosis Mode Description
SELF-DIAG RESULTS The IPDM E/R performs diagnosis of the CAN communication and self-diagnosis.
DATA MONITOR The input/output data of the IPDM E/R is displayed in real time.
CAN DIAG SUPPORT MNTR The result of transmit/receive diagnosis of CAN communication can be read.
ACTIVE TEST The IPDM E/R sends a drive signal to electronic components to check their operation.
PBIB1069E
BCIA0029E
BCIA0030E

Nissan 350Z Workshop Maunual 2005 (31) Summary of Content

PG-18IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)Revision: 2005 August 2005 350ZCONSULT-II Function (IPDM E/R) AKS00A2LCONSULT-II can display each diagnostic item using the diagnostic test modes shown following.CONSULT-II BASIC OPERATIONCAUTION:If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might bedetected in self-diagnosis depending on control unit which carry out CAN communication.1. With the ignition switch OFF, connect CONSULT-II and CON-SULT-II CONVERTER to the data link connector, then turn theignition switch ON.2. Touch START (NISSAN BASED VHCL).3. Touch IPDM E/R on SELECT SYSTEM screen.If IPDM E/R is not displayed, refer to GI-39, "CONSULT-II DataLink Connector (DLC) Circuit" .Inspection Item, Diagnosis Mode DescriptionSELF-DIAG RESULTS The IPDM E/R performs diagnosis of the CAN communication and self-diagnosis.DATA MONITOR The input/output data of the IPDM E/R is displayed in real time.CAN DIAG SUPPORT MNTR The result of transmit/receive diagnosis of CAN communication can be read.ACTIVE TEST The IPDM E/R sends a drive signal to electronic components to check their operation.PBIB1069EBCIA0029EBCIA0030E