Nissan 350Z Workshop Maunual 2005 (31) PDF | Page 26

PG-26
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
Revision: 2005 August 2005 350Z
IPDM E/R Power/Ground Circuit Inspection AKS00A2P
1. CHECK FUSE AND FUSIBLE LINK
Make sure the following fusible links or IPDM E/R fuses are not blown.
OK or NG
OK >> GO TO 2.
NG >> If fuse or fusible link is blown, be sure to eliminate cause of malfunction before installing new fuse
or fusible link.
2. CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R harness connector E3.
3. Check voltage between IPDM E/R harness connector E3 termi-
nals 1 (W), 2 (W/L) and ground.
OK or NG
OK >> GO TO 3.
NG >> Replace IPDM E/R power supply circuit harness.
3. CHECK GROUND CIRCUIT
1. Disconnect IPDM E/R harness connectors E8 and E9.
2. Check continuity between IPDM E/R harness connectors E8 ter-
minal 38 (B), E9 terminal 50 (B), 60 (B) and ground.
OK or NG
OK >> INSPECTION END
NG >> Replace ground circuit harness of IPDM E/R.
Terminal No. Signal name Fuse and fusible link No.
1, 2 Battery power
C
E
71
78
1, 2 ? Ground : Battery voltage
PKIB6562E
38, 50, 60 ? Ground : Continuity should exist.
SKIA6184E

Nissan 350Z Workshop Maunual 2005 (31) Summary of Content

PG-26IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)Revision: 2005 August 2005 350ZIPDM E/R Power/Ground Circuit Inspection AKS00A2P1. CHECK FUSE AND FUSIBLE LINKMake sure the following fusible links or IPDM E/R fuses are not blown.OK or NGOK GO TO 2.NG If fuse or fusible link is blown, be sure to eliminate cause of malfunction before installing new fuseor fusible link.2. CHECK POWER SUPPLY CIRCUIT1. Turn ignition switch OFF.2. Disconnect IPDM E/R harness connector E3.3. Check voltage between IPDM E/R harness connector E3 termi-nals 1 (W), 2 (W/L) and ground.OK or NGOK GO TO 3.NG Replace IPDM E/R power supply circuit harness.3. CHECK GROUND CIRCUIT1. Disconnect IPDM E/R harness connectors E8 and E9.2. Check continuity between IPDM E/R harness connectors E8 ter-minal 38 (B), E9 terminal 50 (B), 60 (B) and ground.OK or NGOK INSPECTION ENDNG Replace ground circuit harness of IPDM E/R.Terminal No. Signal name Fuse and fusible link No.1, 2 Battery powerCE71781, 2 Ground : Battery voltagePKIB6562E38, 50, 60 Ground : Continuity should exist.SKIA6184E