Nissan 350Z Workshop Maunual 2005 (39) PDF | Page 15

STARTING SYSTEM
SC-15
C
D
E
F
G
H
I
J
L
M
A
B
SC
Revision: 2005 August 2005 350Z
Trouble Diagnoses with Battery/Starting/Charging System Tester AKS0098T
NOTE:
To ensure a complete and thorough diagnosis, the battery, starter and generator test segments must be done
as a set from start to finish.
1. Turn off all loads on the vehicle electrical system.
2. Perform battery test with Battery/Starting/Charging system
tester. Refer to SC-7, "
Trouble Diagnoses with Battery/Starting/
Charging System Tester" .
3. Press ?ENTER? to begin the starting system test.
4. Start the engine.
5. Diagnostic result is displayed on the tester. Refer to SC-15,
"DIAGNOSTIC RESULT ITEM CHART" .
NOTE:
? If the starter performs normally but the engine does not start,
perform engine diagnosis.
? For intermittent ?NO CRANK? or ?NO STARTER OPERA-
TION? incidents, refer to SC-18, "
DIAGNOSTIC PROCE-
DURE 2" .
DIAGNOSTIC RESULT ITEM CHART
SEL408X
SEL409X
SEL410X
Diagnostic item Service procedure
CRANKING VOLTAGE NORMAL
Go to SC-16, "
WORK FLOW" .
CRANKING VOLTAGE LOW
CHARGE BATTERY
Perform the slow battery charging procedure. (Initial rate of charge is 10A for 12 hours.) Per-
form battery test again with Battery/Starting/Charging system tester. Refer to SC-7, "Trouble
Diagnoses with Battery/Starting/Charging System Tester" .
REPLACE BATTERY
Before replacing battery, clean the battery cable clamps and battery posts. Perform battery
test again with Battery/Starting/Charging system tester. Refer to SC-7, "
Trouble Diagnoses
with Battery/Starting/Charging System Tester" . If second test result is ?REPLACE BAT-
TERY?, then do so. Perform battery test again to confirm repair.

Summary of Content

STARTING SYSTEMSC-15CDEFGHIJLMABSCRevision: 2005 August 2005 350ZTrouble Diagnoses with Battery/Starting/Charging System Tester AKS0098TNOTE:To ensure a complete and thorough diagnosis, the battery, starter and generator test segments must be doneas a set from start to finish.1. Turn off all loads on the vehicle electrical system.2. Perform battery test with Battery/Starting/Charging systemtester. Refer to SC-7, "Trouble Diagnoses with Battery/Starting/Charging System Tester" .3. Press ENTER to begin the starting system test.4. Start the engine.5. Diagnostic result is displayed on the tester. Refer to SC-15,"DIAGNOSTIC RESULT ITEM CHART" .NOTE: If the starter performs normally but the engine does not start,perform engine diagnosis. For intermittent NO CRANK or NO STARTER OPERA-TION incidents, refer to SC-18, "DIAGNOSTIC PROCE-DURE 2" .DIAGNOSTIC RESULT ITEM CHARTSEL408XSEL409XSEL410XDiagnostic item Service procedureCRANKING VOLTAGE NORMALGo to SC-16, "WORK FLOW" .CRANKING VOLTAGE LOWCHARGE BATTERYPerform the slow battery charging procedure. (Initial rate of charge is 10A for 12 hours.) Per-form battery test again with Battery/Starting/Charging system tester. Refer to SC-7, "Trouble Diagnoses with Battery/Starting/Charging System Tester" .REPLACE BATTERYBefore replacing battery, clean the battery cable clamps and battery posts. Perform battery test again with Battery/Starting/Charging system tester. Refer to SC-7, "Trouble Diagnoses with Battery/Starting/Charging System Tester" . If second test result is REPLACE BAT-TERY, then do so. Perform battery test again to confirm repair.