Nissan 350Z Workshop Maunual 2005 (9) PDF | Page 39

WHEEL SENSORS
BRC-39
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Revision: 2005 August 2005 350Z
WHEEL SENSORS PFP:47910
Removal and Installation AFS0029L
REMOVAL
Pay attention to the following when removing sensor.
CAUTION:
? As much as possible, avoid rotating sensor when removing it. Pull sensors out without pulling on
sensor harness.
? Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before
removing front or rear wheel hub. This is to avoid damage to sensor wiring and loss of sensor
function.
INSTALLATION
Pay attention to the following when installing sensor. Tighten installation bolts and nuts to specified torques.
? When installing, check that there is no foreign material such as iron chips on pick-up and mounting hole of
the sensor. Check that no foreign material has been caught in the sensor rotor motor. Remove any foreign
material and clean the mount.
? When installing front sensor, be sure to press rubber grommets in until they lock at the three locations
shown in diagram (2 at shock absorbers and 1 at body panel). When installed, harness must not be
twisted. White line on harness (shaded part) must be visible from front.
PFIA0241E

Summary of Content

WHEEL SENSORSBRC-39[ABS]CDEGHIJKLMABBRCRevision: 2005 August 2005 350ZWHEEL SENSORS PFP:47910Removal and Installation AFS0029LREMOVALPay attention to the following when removing sensor.CAUTION: As much as possible, avoid rotating sensor when removing it. Pull sensors out without pulling onsensor harness. Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first beforeremoving front or rear wheel hub. This is to avoid damage to sensor wiring and loss of sensorfunction.INSTALLATIONPay attention to the following when installing sensor. Tighten installation bolts and nuts to specified torques. When installing, check that there is no foreign material such as iron chips on pick-up and mounting hole ofthe sensor. Check that no foreign material has been caught in the sensor rotor motor. Remove any foreignmaterial and clean the mount. When installing front sensor, be sure to press rubber grommets in until they lock at the three locationsshown in diagram (2 at shock absorbers and 1 at body panel). When installed, harness must not betwisted. White line on harness (shaded part) must be visible from front.PFIA0241E