Nissan 350Z Workshop Maunual 2005 (9) PDF | Page 41

ABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
BRC-41
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Revision: 2005 August 2005 350Z
ABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY) PFP:47660
Removal and Installation AFS0029N
Pay attention to the following when removing actuator.
CAUTION:
? Before servicing, disconnect battery cables.
? To remove brake tube, use flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use flare nut wrench (commercial service tool).
? Do not remove and install actuator by holding harness.
? After work is completed, bleed air from brake piping. Refer to BR-11, "Bleeding Brake System" .
? Be sure to securely connect the ground cable.
SFIA0631E

Summary of Content

ABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)BRC-41[ABS]CDEGHIJKLMABBRCRevision: 2005 August 2005 350ZABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY) PFP:47660Removal and Installation AFS0029NPay attention to the following when removing actuator.CAUTION: Before servicing, disconnect battery cables. To remove brake tube, use flare nut wrench to prevent flare nuts and brake tube from being dam-aged. To install, use flare nut wrench (commercial service tool). Do not remove and install actuator by holding harness. After work is completed, bleed air from brake piping. Refer to BR-11, "Bleeding Brake System" . Be sure to securely connect the ground cable.SFIA0631E