Nissan 350Z Workshop Maunual 2006 (1) PDF | Page 3

ACCELERATOR CONTROL SYSTEM
ACC-3
C
D
E
F
G
H
I
J
K
L
M
A
ACC
Revision: 2005 August 2006 350Z
ACCELERATOR CONTROL SYSTEM PFP:18005
Removal and Installation NBS000JA
REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Loosen nuts, and remove accelerator pedal assembly.
CAUTION:
? Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sen-
sor from accelerator pedal assembly.
? Avoid impact from dropping etc. during handling.
? Be careful to keep accelerator pedal assembly away from water.
INSTALLATION
Installation is the reverse order of removal.
INSPECTION AFTER INSTALLATION
? Make sure that accelerator pedal moves smoothly within the whole operation range.
? Make sure that accelerator pedal securely returns to the original position.
? For the electrical inspection of accelerator pedal assembly, refer to EC-618, "DTC P2122, P2123 APP
SENSOR" , EC-626, "DTC P2127, P2128 APP SENSOR" and EC-642, "DTC P2138 APP SENSOR" .
CAUTION:
When harness connector of accelerator pedal position sensor is disconnected, perform ?Accelera-
tor Pedal Released Position Learning?. Refer to EC-78, "
Accelerator Pedal Released Position
Learning" .
1. Accelerator pedal assembly
PBIC1920E

Summary of Content

ACCELERATOR CONTROL SYSTEMACC-3CDEFGHIJKLMAACCRevision: 2005 August 2006 350ZACCELERATOR CONTROL SYSTEM PFP:18005Removal and Installation NBS000JAREMOVAL1. Disconnect accelerator pedal position sensor harness connector.2. Loosen nuts, and remove accelerator pedal assembly.CAUTION: Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sen-sor from accelerator pedal assembly. Avoid impact from dropping etc. during handling. Be careful to keep accelerator pedal assembly away from water.INSTALLATIONInstallation is the reverse order of removal.INSPECTION AFTER INSTALLATION Make sure that accelerator pedal moves smoothly within the whole operation range. Make sure that accelerator pedal securely returns to the original position. For the electrical inspection of accelerator pedal assembly, refer to EC-618, "DTC P2122, P2123 APPSENSOR" , EC-626, "DTC P2127, P2128 APP SENSOR" and EC-642, "DTC P2138 APP SENSOR" .CAUTION:When harness connector of accelerator pedal position sensor is disconnected, perform Accelera-tor Pedal Released Position Learning. Refer to EC-78, "Accelerator Pedal Released PositionLearning" . 1. Accelerator pedal assemblyPBIC1920E