Nissan 350Z Workshop Maunual 2006 (25) PDF | Page 9

TROUBLE DIAGNOSES WORK FLOW
LAN-9
[CAN]
C
D
E
F
G
H
I
J
L
M
A
B
LAN
Revision: 2005 August 2006 350Z
HOW TO USE CHECK SHEET TABLE
1. Unit names displayed on CONSULT-II
2. ?No indication?: Put a check mark to it if the unit name described in step 1 is not displayed on ?SELECT
SYSTEM? screen of CONSULT-II. (Unit communicating with CONSULT-II via CAN communication line)
???: Column not used (Unit communicating with CONSULT-II excluding CAN communication line)
3. ?NG?: Display ?NG? when malfunction is detected in the initial diagnosis of the diagnosed unit. Replace the
unit if ?NG? is displayed.
???: Column not used (Initial diagnosis is not performed.)
4. ?UNKWN?: Display ?UNKWN? when the diagnosed unit does not transmit the data normally. Put a check
mark to it if ?UNKWN? is displayed on CONSULT-II.
5. ?UNKWN?: Display ?UNKWN? when the diagnosed unit does not receive the data normally. Put a check
mark to it if ?UNKWN? is displayed on CONSULT-II.
???: Column not used (It is not necessary for CAN communication trouble diagnosis.)
NOTE:
CAN communication diagnosis checks if CAN communication works normally. (Contents of data are not diag-
nosed.)
? When the initial conditions are reproduced, refer to LAN-10, "Example of Filling in Check Sheet When Ini-
tial Conditions Are Reproduced" .
? When the initial conditions are not reproduced, refer to LAN-13, "Example of Filling in Check Sheet When
Initial Conditions Are Not Reproduced" .
PKIC4646E