Nissan 350Z Workshop Maunual 2006 (9) PDF | Page 29

TROUBLE DIAGNOSIS FOR SYSTEM
BRC-29
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Revision: 2005 August 2006 350Z
ABS Actuator and Electric Unit (Control Unit) NFS00028
INSPECTION PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Check self-diagnosis results.
Is the above displayed in the self-diagnosis display items?
YES >> Replace the ABS actuator and electric unit (control unit). Re-conduct ABS actuator and electric
unit (control unit) self-diagnosis.
NO >> INSPECTION END
ABS Actuator and Electric Unit (Control Unit) Power and Ground Systems NFS00029
INSPECTION PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Check self-diagnosis results.
Is the above displayed in the self-diagnosis display items?
YES >> GO TO 2.
NO >> INSPECTION END
2. CHECK CONNECTOR
1. Disconnect ABS actuator and electric unit (control unit) control unit connector and check terminal for
deformation, disconnection, looseness, and so on, If there is an error, repair or replace the terminal.
2. Securely reconnect the connector and then perform self-diagnosis.
Is the result of self-diagnosis normal?
YES >> The connector terminal contact is loose, damaged, open or shorted.
NO >> GO TO 3.
Self-diagnosis results
CONTROLLER FAILURE
Self-diagnosis results
BATTERY VOLTAGE [ABNORMAL]

Summary of Content

TROUBLE DIAGNOSIS FOR SYSTEMBRC-29[ABS]CDEGHIJKLMABBRCRevision: 2005 August 2006 350ZABS Actuator and Electric Unit (Control Unit) NFS00028INSPECTION PROCEDURE1. CHECK SELF-DIAGNOSIS RESULTSCheck self-diagnosis results.Is the above displayed in the self-diagnosis display items?YES Replace the ABS actuator and electric unit (control unit). Re-conduct ABS actuator and electricunit (control unit) self-diagnosis.NO INSPECTION ENDABS Actuator and Electric Unit (Control Unit) Power and Ground Systems NFS00029INSPECTION PROCEDURE1. CHECK SELF-DIAGNOSIS RESULTSCheck self-diagnosis results.Is the above displayed in the self-diagnosis display items?YES GO TO 2.NO INSPECTION END2. CHECK CONNECTOR 1. Disconnect ABS actuator and electric unit (control unit) control unit connector and check terminal fordeformation, disconnection, looseness, and so on, If there is an error, repair or replace the terminal. 2. Securely reconnect the connector and then perform self-diagnosis. Is the result of self-diagnosis normal?YES The connector terminal contact is loose, damaged, open or shorted.NO GO TO 3.Self-diagnosis resultsCONTROLLER FAILURESelf-diagnosis resultsBATTERY VOLTAGE [ABNORMAL]