Nissan 350Z Workshop Maunual 2006 (9) PDF | Page 33

TROUBLE DIAGNOSIS FOR SYSTEM
BRC-33
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Revision: 2005 August 2006 350Z
ABS Actuator and Electric Unit (Control Unit) 2 NFS0002C
INSPECTION PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Check self-diagnosis results.
When any item other than ?EMERGENCY BRAKE? is indicated in self-diagnosis display, follow the instructions
below.
CAUTION:
?EMERGENCY BRAKE? is indicated when control unit itself is detected as an error. If this display item
is indicated, replace control unit.
Is the above displayed in the self-diagnosis display items?
YES >> Replace the ABS actuator and electric unit (control unit).
NO >> INSPECTION END
CAN Communication System NFS0002D
INSPECTION PROCEDURE
1. CHECK CONNECTOR
1. Turn ignition switch OFF, disconnect the ABS actuator and electric unit (control unit) connector, and check
terminal for deformation, disconnection, looseness, and so on. If there is a malfunction, repair or replace
the terminal.
2. Reconnect connector to perform self-diagnosis.
Is
?CAN COMM CIRCUIT? displayed in the self-diagnosis display items?
YES >> Print out the self-diagnostic results, and refer to LAN-3, "Precautions When Using CONSULT-II" .
NO >> Connector terminal connector is loose, damaged, open, or shorted.
Self-diagnosis results
EMERGENCY BRAKE

Summary of Content

TROUBLE DIAGNOSIS FOR SYSTEMBRC-33[ABS]CDEGHIJKLMABBRCRevision: 2005 August 2006 350ZABS Actuator and Electric Unit (Control Unit) 2 NFS0002CINSPECTION PROCEDURE1. CHECK SELF-DIAGNOSIS RESULTSCheck self-diagnosis results.When any item other than EMERGENCY BRAKE is indicated in self-diagnosis display, follow the instructionsbelow.CAUTION:EMERGENCY BRAKE is indicated when control unit itself is detected as an error. If this display itemis indicated, replace control unit.Is the above displayed in the self-diagnosis display items?YES Replace the ABS actuator and electric unit (control unit).NO INSPECTION ENDCAN Communication System NFS0002DINSPECTION PROCEDURE1. CHECK CONNECTOR1. Turn ignition switch OFF, disconnect the ABS actuator and electric unit (control unit) connector, and checkterminal for deformation, disconnection, looseness, and so on. If there is a malfunction, repair or replacethe terminal.2. Reconnect connector to perform self-diagnosis.Is CAN COMM CIRCUIT displayed in the self-diagnosis display items?YES Print out the self-diagnostic results, and refer to LAN-3, "Precautions When Using CONSULT-II" .NO Connector terminal connector is loose, damaged, open, or shorted.Self-diagnosis resultsEMERGENCY BRAKE