Nissan 350Z Workshop Maunual 2006 (9) PDF | Page 36

BRC-36
[ABS]
WHEEL SENSORS
Revision: 2005 August 2006 350Z
WHEEL SENSORS PFP:47910
Removal and Installation NFS0002J
COMPONENTS
REMOVAL
Pay attention to the following when removing sensor.
CAUTION:
? As much as possible, avoid rotating sensor when removing it. Pull sensors out without pulling on
sensor harness.
? Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before
removing front or rear wheel hub. This is to avoid damage to sensor wiring and loss of sensor
function.
INSTALLATION
Pay attention to the following when installing sensor. Tighten installation bolts and nuts to specified torques.
? When installing, check that there is no foreign material such as iron chips on pick-up and mounting hole of
the sensor. Check that no foreign material has been caught in the sensor rotor motor. Remove any foreign
material and clean the mount.
? When installing front sensor, be sure to press rubber grommets in until they lock at the three locations
shown in diagram (2 at shock absorbers and 1 at body panel). When installed, harness must not be
twisted. White line on harness (shaded part) must be visible from front.
PFIA0241E