ABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
Revision: 2005 August 2006 350Z
ABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY) PFP:47660
Removal and Installation NFS0002L
Pay attention to the following when removing actuator.
? Before servicing, disconnect battery cables.
? To remove brake tube, use flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use flare nut wrench (commercial service tool).
? Do not remove and install actuator by holding harness.
? After work is completed, bleed air from brake piping. Refer to BR-11, "Bleeding Brake System" .
? Be sure to securely connect the ground cable.