Nissan 350Z Workshop Maunual 2006 (9) PDF | Page 39

PRECAUTIONS
BRC-39
[TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
Revision: 2005 August 2006 350Z
[TCS/ABS]
PRECAUTIONS PFP:00001
Precautions for Supplemental Restraint System (SRS) ?AIR BAG? and ?SEAT
BELT PRE-TENSIONER?
NFS0002M
The Supplemental Restraint System such as ?AIR BAG? and ?SEAT BELT PRE-TENSIONER?, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
? To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
? Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
? Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
Precautions for Battery Service NFS0002N
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-
ence between the window edge and the vehicle when the door is opened/closed. During normal operation, the
window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic
window function will not work with the battery disconnected.
Precautions for Brake System NFS0002O
? Recommended fluid is brake fluid ?DOT 3?. Refer to MA-12, "RECOMMENDED FLUIDS AND LUBRI-
CANTS" .
? Never reuse drained brake fluid.
? Be careful not to splash brake fluid on painted areas such as body. If brake fluid is splashed, wipe it off
and flush area with water immediately.
? Never use mineral oils such as gasoline or kerosene. They will ruin rubber parts of the hydraulic system.
? Use a flare nut wrench when removing flare nuts, and use a flare
nut torque wrench when tighten brake tube flare nuts.
? When installing brake tubes, be sure to check torque.
? Brake system is an important safety part. If a brake fluid leak is
detected, always disassemble the affected part. If a malfunction
is detected, replace part with a new one.
? Before working, turn ignition switch OFF and disconnect electri-
cal connector of ABS actuator and electric unit (control unit) or
the battery cables.
WARNING:
Clean brake pads and shoes with a waste cloth, then wipe with
a dust collector.
Precautions for Brake Control NFS0002P
? During ABS operation, brake pedal lightly vibrates and a mechanical noise may be heard. This is normal.
? Just after starting vehicle after ignition switch ON, brake pedal may vibrate or motor operating noise may
be heard from engine compartment. This is a normal status of operation check.
? Stopping distance may be longer than that of vehicles without ABS when vehicle drives on rough, gravel,
or snow-covered (fresh, deep snow) roads.
? When an error is indicated by ABS or another warning lamp, collect all necessary information from cus-
tomer (what symptoms are present under what conditions) and check for simple causes before starting
SBR686C

Nissan 350Z Workshop Maunual 2006 (9) Summary of Content

PRECAUTIONSBRC-39[TCS/ABS]CDEGHIJKLMABBRCRevision: 2005 August 2006 350Z[TCS/ABS]PRECAUTIONS PFP:00001Precautions for Supplemental Restraint System (SRS) AIR BAG and SEAT BELT PRE-TENSIONERNFS0002MThe Supplemental Restraint System such as AIR BAG and SEAT BELT PRE-TENSIONER, used alongwith a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certaintypes of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRSsystem uses the seat belt switches to determine the front air bag deployment, and may only deploy one frontair bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.Information necessary to service the system safely is included in the SRS and SB section of this Service Man-ual.WARNING: To avoid rendering the SRS inoperative, which could increase the risk of personal injury or deathin the event of a collision which would result in air bag inflation, all maintenance must be per-formed by an authorized NISSAN/INFINITI dealer. Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and AirBag Module, see the SRS section. Do not use electrical test equipment on any circuit related to the SRS unless instructed to in thisService Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses orharness connectors.Precautions for Battery Service NFS0002NBefore disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-ence between the window edge and the vehicle when the door is opened/closed. During normal operation, thewindow slightly raises and lowers automatically to prevent any window to vehicle interference. The automaticwindow function will not work with the battery disconnected.Precautions for Brake System NFS0002O Recommended fluid is brake fluid DOT 3. Refer to MA-12, "RECOMMENDED FLUIDS AND LUBRI-CANTS" . Never reuse drained brake fluid. Be careful not to splash brake fluid on painted areas such as body. If brake fluid is splashed, wipe it offand flush area with water immediately. Never use mineral oils such as gasoline or kerosene. They will ruin rubber parts of the hydraulic system. Use a flare nut wrench when removing flare nuts, and use a flarenut torque wrench when tighten brake tube flare nuts. When installing brake tubes, be sure to check torque. Brake system is an important safety part. If a brake fluid leak isdetected, always disassemble the affected part. If a malfunctionis detected, replace part with a new one. Before working, turn ignition switch OFF and disconnect electri-cal connector of ABS actuator and electric unit (control unit) orthe battery cables.WARNING:Clean brake pads and shoes with a waste cloth, then wipe witha dust collector. Precautions for Brake Control NFS0002P During ABS operation, brake pedal lightly vibrates and a mechanical noise may be heard. This is normal. Just after starting vehicle after ignition switch ON, brake pedal may vibrate or motor operating noise maybe heard from engine compartment. This is a normal status of operation check. Stopping distance may be longer than that of vehicles without ABS when vehicle drives on rough, gravel,or snow-covered (fresh, deep snow) roads. When an error is indicated by ABS or another warning lamp, collect all necessary information from cus-tomer (what symptoms are present under what conditions) and check for simple causes before startingSBR686C