Subaru Forester AutomaticTransmission 1999 2000 (55) PDF

B: INSTALLATION
1) Install TCM to brake pedal bracket.
Tightening torque:
7.4
2.0 Nm (0.75
0.2 kg-m, 5.4
1.4 ft-lb)
B3M1667A
(A) Transmission control module
(B) Brake pedal bracket
2) Connect connectors to TCM.
3) Install lower cover and then connect connector.
4) Connect battery terminal.
24. Dropping Resistor
A: REMOVAL AND INSTALLATION
1) Disconnect battery ground terminal.
G6M0095
2) Remove air intake duct. <Ref. to 2-7 [W1A0].>
3) Disconnect connector from dropping resistor.
4) Remove dropping resistor from bracket.
B3M1670
5) Install dropping resistor.
Tightening torque:
6.4
0.5 Nm (0.65
0.05 kg-m, 4.7
0.4 ft-lb)
B3M1670
6) Install in the reverse order of removal.
112
3-2 [W23B0] SERVICE PROCEDURE
24. Dropping Resistor

Subaru Forester AutomaticTransmission 1999 2000 (55) Summary of Content

B: INSTALLATION1) Install TCM to brake pedal bracket.Tightening torque:7.42.0 Nm (0.750.2 kg-m, 5.41.4 ft-lb)B3M1667A(A) Transmission control module(B) Brake pedal bracket2) Connect connectors to TCM.3) Install lower cover and then connect connector.4) Connect battery terminal.24. Dropping ResistorA: REMOVAL AND INSTALLATION1) Disconnect battery ground terminal.G6M00952) Remove air intake duct. Ref. to 2-7 [W1A0].3) Disconnect connector from dropping resistor.4) Remove dropping resistor from bracket.B3M16705) Install dropping resistor.Tightening torque:6.40.5 Nm (0.650.05 kg-m, 4.70.4 ft-lb)B3M16706) Install in the reverse order of removal.1123-2 [W23B0] SERVICE PROCEDURE24. Dropping Resistor