Subaru Forester Body and Exterior 1999 2000 (19) PDF

8. Front Fender
A: REMOVAL AND INSTALLATION
1) Disconnect ground cable from battery.
2) Remove mud guard. <Ref. to 5-1 [W9A0].>
3) Remove parking light and headlight. <Ref. to
6-2 [W4B1].>
4) Remove front bumper face. <Ref. to 5-1
[W3A0].>
5) Remove side protector. (Front fender) <Ref. to
5-1 [W7A0].>
6) Remove attaching bolt then remove fender.
CAUTION:
Be careful not to scratch body panels with
fender edges when removing it.
S5M0165
7) Install in the reverse order of removal.
NOTE:
Check for alignment of front fender with hood and
front door with front fender at all points. Adjust, if
necessary.
G5M0175
G5M0176
9. Mud Guard
A: REMOVAL AND INSTALLATION
1) Jack-up vehicle and remove tire.
2) Remove screws and clips. Move mud guard
toward the center of the body and remove mud
guard.
S5M0166
3) Install in the reverse order of removal.
CAUTION:
Only use new nuts and clips.
39
[W9A0] 5-1SERVICE PROCEDURE
9. Mud Guard

Subaru Forester Body and Exterior 1999 2000 (19) Summary of Content

8. Front FenderA: REMOVAL AND INSTALLATION1) Disconnect ground cable from battery.2) Remove mud guard. Ref. to 5-1 [W9A0].3) Remove parking light and headlight. Ref. to6-2 [W4B1].4) Remove front bumper face. Ref. to 5-1[W3A0].5) Remove side protector. (Front fender) Ref. to5-1 [W7A0].6) Remove attaching bolt then remove fender.CAUTION:Be careful not to scratch body panels withfender edges when removing it.S5M01657) Install in the reverse order of removal.NOTE:Check for alignment of front fender with hood andfront door with front fender at all points. Adjust, ifnecessary.G5M0175G5M01769. Mud GuardA: REMOVAL AND INSTALLATION1) Jack-up vehicle and remove tire.2) Remove screws and clips. Move mud guardtoward the center of the body and remove mudguard.S5M01663) Install in the reverse order of removal.CAUTION:Only use new nuts and clips.39[W9A0] 5-1SERVICE PROCEDURE9. Mud Guard