Subaru Forester Body Electrical System 1999 2000 (11) PDF

2. HEADLIGHT RELAY
Check continuity between terminals when terminal
No. 4 is connected to battery and terminal No. 3 is
grounded.
When current
flows
Between terminals
No. 1 and No. 2
Continuity exists.
When current
does not flow
Between terminals
No. 1 and No. 2
Continuity does not
exist.
Between terminals
No. 3 and No. 4
Continuity exists.
S6M0048B
3. TAIL AND ILLUMINATION RELAY
Check continuity between terminals (indicated in
table below) when terminal No. 4 is connected to
battery and terminal No. 3 is grounded.
When current
flows
Between terminals
No. 1 and No. 2
Continuity exists.
When current
does not flow
Between terminals
No. 1 and No. 2
Continuity does not
exist.
Between terminals
No. 3 and No. 4
Continuity exists.
S6M0048B
5. Front Wiper and Washer
A: ADJUSTMENT
1) Turn the wiper switch to OFF position.
2) Adjust so that the blades meet the ceramic print
point mark (A).
S6M0049B
3) Adjust washer ejecting area on windshield
glass as shown in the figure when vehicle stops.
Ejecting area:
A: 350 mm (13.78 in)
B: 100 mm (3.94 in)
C: 60 mm (2.36 in)
B6M1315A
8
6-2 [W4C2] SERVICE PROCEDURE
5. Front Wiper and Washer

Subaru Forester Body Electrical System 1999 2000 (11) Summary of Content

2. HEADLIGHT RELAYCheck continuity between terminals when terminalNo. 4 is connected to battery and terminal No. 3 isgrounded.When currentflowsBetween terminalsNo. 1 and No. 2Continuity exists.When currentdoes not flowBetween terminalsNo. 1 and No. 2Continuity does notexist.Between terminalsNo. 3 and No. 4Continuity exists.S6M0048B3. TAIL AND ILLUMINATION RELAYCheck continuity between terminals (indicated intable below) when terminal No. 4 is connected tobattery and terminal No. 3 is grounded.When currentflowsBetween terminalsNo. 1 and No. 2Continuity exists.When currentdoes not flowBetween terminalsNo. 1 and No. 2Continuity does notexist.Between terminalsNo. 3 and No. 4Continuity exists.S6M0048B5. Front Wiper and WasherA: ADJUSTMENT1) Turn the wiper switch to OFF position.2) Adjust so that the blades meet the ceramic printpoint mark (A).S6M0049B3) Adjust washer ejecting area on windshieldglass as shown in the figure when vehicle stops.Ejecting area:A: 350 mm (13.78 in)B: 100 mm (3.94 in)C: 60 mm (2.36 in)B6M1315A86-2 [W4C2] SERVICE PROCEDURE5. Front Wiper and Washer